Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Includes 4 rubber washers, 4 metal washers, and 4 screws.
Our Kenmore Series 70 washer no longer spun during the rinse and spin cycle. After scouring the resource on the internet, the lid switch checked out OK, so it boiled down to the wig wag solenoid unit that engages the transmission. The back panel was opened and a check with a multimeter showed one of the solenoids was an open circuit and provided no resistance reading. Removal of the old unit required some finessing with a prying tool and hammer to force it off of the shaft. The new unit... Read more
Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either! Read more
Researched this kenmore washer on-line and found the problem to be the lid switch. Saw a diagram on how to jump this switch by connecting a wire to both outside wires on the harness and voila! It worked! This is not a fix but it allowed me to finish the load of unwashed clothes and told me which part was bad (do not run washer jumped like this.......fire hazard!) Ordered the lid switch and it was an easy repair. A $14.00 switch was a lot cheaper than a $450.00 washer. Thanks appliance parts... Read more
Watched supplied video; pulled off the remnant and popped replacement part back on. EZ PZ. only problem, took one week to receive part. surprised cause last thing I ordered took only 2 days. Read more
Called AppliancePartsPros who told me what I needed and even placed the order for me. Voila, that simple. Read more
I took the old one off and replaced it with a new one. Read more
I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more