Amana Ntw4631bq0 Parts

Watched a video online, the project took about 20 minutes, went well, parts fit good, the video was very helpful in getting the wash machine up and running. Read more

Purchased water inlet valve and new hot and cold water hoses. Unscrewed about 5 screws that were holding the top of the washer in place then slide the top forward and up. Released the control top it popped off no screws. Disconnected the wires attached and unscrewed 2 screws holding the valve in place the popped that off. Popped in a new valve and repeated the process in reverse. Boom done! Very simple works like new! Read more

Completely removed dryer drum cleaned surfaces ready for paint applied paint acquired from you it did a wonderful job with one can of paint will use for a while and acquire another can of paint for second coat thank you so much for your help the whirlpool dryer drum paint was exactly what it said it would do Read more

We found the pump online at AppliancePartsPros.com for our model of Maytag. When we found the part, there was a video posted that was for our exact pump and washer. After watching it, we called Appliance Parts Pros to verify the part. The customer service representative was incredibly helpful and confirmed our diagnosis. We ordered the pump as well as hoses and clamps in case we needed them. We ordered them overnight delivery and the customer service rep said that we might not receive it... Read more

Replaced it with a new gear housing assembly. It was some what difficult removing the spindle hub. Read more

Pulled off the old broken part, and replaced with the new one. It snapped off and on easily. Read more

Prior to ordering parts I had pulled the pump strainer basket and cleaned it out. There was both soft and hard scale build up. The tub-to-pump hose was also pretty crusty/slimey. Still got warnings for SUDS and repeated F02 errors. Ordered parts and replaced the pump, tub-to-pump hose, interior drain hose and exterior drain hose (both hoses has some slime build up). The water standing in the tub when I emptied it the first time had very little suds but we kept getting the SUDS warning. ... Read more

I had the problem couple years ago I bypassed unbalance switch it worked fine for a couple years and had the same problem again so ruled out unbalanced switch. Door lock light on and checked made sure wax motor pushed out all the way too the second switch for spin check OK, so took a chance on displacement switch x2. My family loves to over load it and also replaced by passed unbalance switch and boom every thing went back to normal. Its also good to clean every thing when apart. Read more

I replaced the lid. Read more