Edw3000g02 Parts

This finished toe kick panel replaces the lower front trim on compatible GE washers and dryers to restore appearance and protect the cabinet base. It provides a clean, finished look and covers the gap between the appliance and the floor. What it does:

• Replaces a damaged, scratched, or bent toe kick to restore the appliance's exterior finish
• Covers and protects the cabinet base from dust, debris, and foot traffic
• Helps maintain a finished, factory appearance after repairs or cabinet work
• Fits where a finished front toe panel is required for proper cosmetic restoration

• Intended for cosmetic replacement; fit to your exact model before installation
• Remove power (unplug or shut off breaker) before accessing panels near controls; follow all safety precautions
• May require removal of lower access panels or screws; retain original fasteners unless replacements are provided

This is a replacement fastener screw used to secure panels and components on compatible appliances, restoring proper fit and reducing movement. It's a simple, direct replacement when an original screw is missing or damaged. What it does:

• Secures access panels, covers, or internal components to prevent rattling and movement
• Helps maintain proper alignment of parts so doors and panels close correctly
• Replaces missing, stripped, or broken screws that can cause loose parts or noise
• Restores the appliance's original fit where a matching OEM fastener is required

• One replacement screw

• Turn off and unplug the appliance before starting any repair
• Use the correct driver and avoid over-tightening to prevent stripping threads
• If the original screw was holding electrical components, ensure power is disconnected and follow OEM safety instructions

Black. 8-18 x 5/16 inch.

Bisque. 8-18 x 5/16 inch.

This long front panel replaces a damaged or worn control-area panel to restore the range's appearance and provide a secure mounting surface for control components. It fits the long control area used on select GE ranges. What it does:

• Replaces cracked, dented or heavily scratched front/control-area panels to improve appearance
• Provides the mounting surface and alignment for control switches and trim
• Helps keep internal components shielded from spills and debris near the controls
• Restores a flush fit where the original panel was warped or bent

• Disconnect power to the appliance (unplug or switch off breaker) before starting work
• Remove control knobs and any trim pieces to access mounting screws; keep original fasteners for reassembly
• Handle the panel carefully to avoid cuts from sharp edges and to prevent cosmetic damage
• Take care when disconnecting and reconnecting wiring;

This E-ring is a small retaining clip that secures shafts, spindles, and components to prevent lateral movement and keep assemblies in place. It restores proper alignment and helps stop parts from slipping off their shafts. What it does:

• Secures shafts and spindles by fitting into a groove to lock components in place
• Prevents lateral movement and component disengagement during operation
• Helps stop rattling or misalignment caused by loose parts
• Small, simple part used where a snap-in retaining clip is required

• Disconnect power before servicing and follow all safety guidelines
• Use snap-ring/needle-nose pliers or appropriate tools to install/remove carefully
• Ensure the ring seats fully in the groove and that the mating parts are correctly positioned
• Inspect mating shaft and groove for wear; replace if damaged