Fgbd2445nwa1 Parts

When I identified a leak coming from the Heating Coil, I saw that the Heating Element Nut on both sides were corroded and could not hold the heating element tight any more. I ordered replacement parts and the fix was very easy. As I was running the test afterwards, I discovered that there was a leak coming from under the door. I realized then that the reason the heating element nut corroded was because of a leak in the door. I ordered a new door gasket and door seal (that goes at the bottom... Read more

Replaced control board and that fixed issue! Also replaced vent assembly due to occasional water leak . Old one showed signs where water leaked past the seal. New one had same design so hopefully will perform better Read more

I had to remove all of the components from one unit over to another. Since I cut the back of the dishwashers tub and the upper spray arm tube with a demo tool at the beginning of the project I figured I could fix it. In order to replace this, every single component had to be removed from the old unit to the new one, it took about an hour for the work to be completed & fairly simple to do. I took a few minutes before removing everything to note where all the wires go then I started to unplug... Read more

We took off the front door cover and found that the vent had failed some time ago- the flap was frozen open, the motor did not work. We removed the three screws and the vent came of- putting the new one back was just that simple except that I had to remove the protective paper from the adhesive covered gasket around the surface of vent. Testing showed that the flap was now free but did not close during the running cycle. I swapped the leads from the dispenser motor with those on the vent and... Read more