Fgfh2631-Pf3 Parts

Phillips head mounting screw for dishwashers and ranges. Secures internal components and panels. Replace if stripped, rusted, or missing during repairs.

Replacement housing cover for your range. Installs on the exterior or internal housing assembly. Order a new cover if yours is cracked, broken, or missing.

Wing nuts for ovens and ranges. Used to secure panels, brackets, and internal components. Replace if stripped, corroded, or missing during repair work.

Mounting bracket that secures the gas pressure regulator to your range frame. Replace if bent, broken, or missing to properly support the regulator assembly.

Insulation strip that installs inside the range oven door to reduce heat loss and dampen sound. Replace if torn, compressed, or missing.

Bisque thermostat knob for range ovens. Replaces cracked, broken, or missing temperature control knobs. Installs on the control panel for oven operation.

Vent opening cover for gas ranges. Replaces cracked, broken, or missing covers that expose the vent area. Installs over the vent opening on the cooktop.

Push-in nylon nut for gas ranges. Secures panels, components, or trim pieces. Replace if cracked, broken, worn, or missing to properly fasten parts.

Anti-tip warning label for ovens and ranges. Replaces faded, peeling, or missing safety labels on the rear or side panel of your appliance.

Replace your range oven door gasket to restore heat seal and improve cooking efficiency. Install when you notice heat escaping or uneven temperatures.

8-18 x 0.5 inch mounting screw for electric and gas ranges. Replaces lost, stripped, or corroded screws used to secure components and panels.

Pressure regulator for gas ranges. Controls gas flow from supply line to burners and oven. Replace if worn, damaged, or causing pressure issues.

Cover plate for gas ranges. Installs on the cooktop or control panel area. Replace if yours is cracked, broken, discolored, or missing for a clean look.

This main wiring harness connects a refrigerator's control board and key components, providing organized power and signal routing so controls, lights and the compressor operate reliably. Replaces a damaged or burned main harness for restored electrical continuity. What it does

• Routes power and signal connections between the control board, lights, compressor and sensors.
• Prevents intermittent operation caused by loose, corroded or broken wiring.
• Can stop failures such as no lights, components not running, or control errors when the harness is the fault.
• Keeps wires organized and secured to avoid chafing and shorting.

• One main wiring harness as pictured.

• Disconnect power before servicing to prevent shock or damage.
• Compare the new harness to the original and route wires the same way; replace any damaged clips or grommets.
• Reconnect all terminals fully; loose connectors can cause intermittent faults.