Kenmore 58716252401 Parts

This thermistor is the dishwasher's temperature sensor. It reports water temperature to the control so the heater and cycle timing are managed correctly, helping restore reliable wash performance and more consistent drying.

• Monitors water temperature in the tub/sump and sends readings to the control board
• Helps the control regulate heater operation and determine cycle progress/timing
• Failure can result in no heat or poor drying
• May cause unusually long/short cycles or temperature-related fault codes

• Disconnect power at the breaker and shut off the water supply before servicing
• Access is typically from the toe-kick/base area or sump; remove the lower access panel as needed
• Release the locking tab/clip, remove the sensor, and ensure the existing seal/O-ring is properly seated; install the new sensor fully to prevent leaks
• Reconnect the wire harness, restore power, and run a test cycle to check for leaks and proper heating

This door gasket is the flexible rubber seal that closes the refrigerator door, helping keep cold air in and reduce energy loss. Replacing a worn or torn gasket restores a tight seal and helps the appliance maintain proper temperature. What it does:

• Seals the cabinet to keep cold air inside and warm air out
• Helps maintain consistent fridge/freezer temperature and efficiency
• Reduces frosting and moisture buildup caused by leaks
• Commonly needed when the seal is cracked, torn, warped, or no longer mates flush with the cabinet

• One replacement door gasket

• Clean the door flange and gasket mounting area before installing to ensure a proper seal
• Inspect for mounting clips or retainer channel; follow appliance-specific alignment steps for a snug fit
• Warm the gasket slightly (per OEM guidance) if needed to ease installation — avoid open flames or excessive heat

This genuine replacement screw secures appliance panels and components so assemblies stay tight and stable. It's a simple, direct fix when a missing or damaged screw causes loose trim, rattling, or misaligned parts. What it does:

• Fastens panels, brackets, and trim to restore proper alignment and stability
• Stops rattling or vibration caused by loose hardware
• Replaces stripped or corroded screws to ensure secure connections
• Works wherever the OEM screw is specified in the appliance

• Use the matching driver and proper torque to avoid stripping the head or threads
• Replace only with the exact OEM screw to maintain fit and function
• Disconnect power before accessing internal components; follow appliance safety instructions
• Replace all like-for-like for best results

Color: White

This replacement brace is a support bracket that helps secure and stabilize appliance panels and components, restoring proper alignment and reducing vibration. Designed for direct fit where the original bracket is damaged or missing. What it does:

• Provides structural support to panels, frames, or assemblies to maintain alignment and fit
• Secures components to prevent wobbling, rattling, or movement during operation
• Helps restore proper door or panel fit when a broken or bent bracket causes misalignment
• Reduces noise caused by loose or unsupported parts

• One replacement brace

• Disconnect power or unplug the appliance before starting any work
• Use the original screw locations and hardware where possible; save any reusable fasteners
• Inspect surrounding panels and mounting points for additional damage before reassembly

This is an adhesive Energy Guide label that mounts on the appliance exterior to show the manufacturer's estimated energy use and rating. Replaces a missing, torn, or unreadable energy guide so ratings are clearly visible. What it does:

• Displays the appliance's estimated energy consumption and efficiency information.
• Restores required labeling if the original guide is damaged or removed.
• Helps homeowners verify energy rating details at a glance.
• Common symptom: label is missing, badly faded, or illegible.

• Surface must be clean, dry, and free of oils or residue before applying.
• Peel-and-stick installation; align carefully—adhesive is permanent and difficult to reposition.
• No tools required; follow the original label location and orientation for compliance.