Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Usually ships within 4 - 14 days
This O-ring is a small rubber replacement seal that helps stop water leaks where two components meet. It restores a tight seal to reduce drips and prevent water damage from worn or cracked seals. What it does:
1. To fix the leaks from around the door, I replaced the upper and lower door seals. These were purchased in a separate transcation, so they are not the parts shown here. The upper door seal worked as intended, but the lower seal would not stay in place on the lower edge of the door during a wash. Therefore I cleaned the grease and detergent off the old seal, and installed using silicone sealer/adhesive. The plastic edge pieces for the lower seal were supplied with the kit, and they installed... Read more
This hose runs from water valve to the inlet on the side of the tank.
Color: Black.
I had no hope of separating the panel from the frame without damaging the frame since the two parts were rusted pretty badly and the screws holding the panel to the frame were completely beyond salvage. So I had to replace both the panel and the frame. I ended up removing the electrical/electronic connections, removing the panel/frame from the hinge and then replacing it with the new parts. Took about 90 minutes but the hardest part was removing other items from the rusting frame without... Read more
This small black clamp secures a hose, tube or wiring harness to prevent movement and abrasion. It's a direct-fit replacement used to keep connections stable so lines stay routed and protected during normal appliance operation. What it does
Optional accessory. Color: White.
I took the top rack out took off old broken rollers and put the new ones in Read more
I followed Matt's awesome video from AppliancePartsPros.com to build up my "I can do this" reserves. But here's the story leading up to that point... We purchased our Samsung WF419 on a “Black Friday” special November 2009 expecting to get some good years out of the washer/dryer pair. We don’t run more than 2 or 3 loads a week in the washer, so ours has had relatively little use over the beginning of its anticipated and expected long life-cycle. When the “thumping” started on the spin cycle a... Read more
The Latch Switch Kit, an OEM Replacement Part is designed to ensure the safe operation of your Whirlpool dishwasher. The kit includes two microswitches and a wiring harness. It prevents the appliance from running when the door is open. If defective, the door switch may prevent the dishwasher from operating even when the door is closed.
Causes of a bad door switch can include wear and tear, exposure to moisture, or a broken actuator.
Symptoms of a bad door switch include:
This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
I ordered the Door Switch Kit, along with a few other items. However, the switch kit was all that was needed. Isimply followed the instructions that came with the kit. It was necessary to cut the wires which connected to the wire assembly in the door of the dishwasher. I then connected the pieces from the switch kit and then connected the end pieces to the door. I closed the door, and started up the dishwasher. It worked as well as before. Read more
The Door Gasket is an OEM part for Whirlpool dishwashers. This gasket is essential for maintaining the efficiency and safety of your dishwasher, ensuring that water is contained within the unit to avoid kitchen floods and water damage.
Causes of deterioration can include regular wear and tear from opening and closing the dishwasher door, exposure to harsh detergents and high temperatures, and physical damage from loading and unloading dishes.
Symptoms of a bad Door Gasket include:
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Replaced door lower seal and door gasket. Read more
Specs: 10 - 16 x .375
Replaced the Injector valve, nozzle and sleeve-in using new hose clamps Read more