Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This replacement cap fits over a range/oven control knob to restore finished appearance and protect the underlying shaft. It snaps into place and matches original white knobs for a cohesive control panel look. What it does:
This small hardware washer serves as a spacer/bearing surface within appliance assemblies to distribute load and maintain proper clearance. Replacing a worn washer helps restore smooth operation and alignment of the affected control or mechanism. What it does:
This was my first ever self appliance repair. The videos provided by Appliance Parts Pros were excellent and gave me the confidence to do the work myself. My Maytag dryer model opened differently than the one in the videos. I had to remove the front panel and screwing in the paddle required reaching way back and working in a small space where I couldn't see what I was doing. It was uncomfortable but doable with a nut driver and a bit of elbow grease. The part fit perfectly and it looks good as... Read more
I had to replace the terminal block due to the 220 volt ark. A small fire at the bottom of the dryer caused the belt to partially burn. I had to replace it along with the 220 volt dryer cable. If the local hardware store would have taken the time to install the dryer with an additional 0.50 cent grommet, this could have been avoided. Thank you for sending the correct parts. This was the second time I had to use your service and I will continue to use it in the future. Read more
Screw kit for front panel.
Replaced the duct outlet assembly and the 2 drum rollers Read more
Replaced felt tumbler seal and tumbler Read more
After some research and some testing with a multimeter, it turned out the lid check switch was bad. Instead of purchasing the entire switch assembly, I purchased just the switch that was bad. The lid switch assembly is easy to disassemble, but requires removing the spring loaded lever to remove the lid cover switch. This is wall current, so make sure you unplug! Installed, test, and everything... still didn't work. When the switch fails it takes the fuse out with it. Since I hadn't ordered... Read more
Unplugged line cord. Removed two phillips screws close to bottom in front and lifted at 30º angle to release top clips on front panel, rotated it aside so as to not disturb door switch wires. Turned drum by hand. Located rattle emanating from blower housing. Removed lint screen and holder with phillips and 1/4" nutdriver. Removed blower housing cover with 1/4" and 5/16" nut driver. Blower wheel's hub was shattered around motor shaft. Ordered new one. Cleaned out lint buildup. Took off... Read more