Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
White. Includes both left and right hand side.
GOT TIRED OF ICKY CLOTHES AND SMELLY SHEETS AND PILLOW CASES, SO ORDERED PARTS TO REPAIR SLIGHTLY DAMAGED MACHINE. BROKE SOME PARTS ON IT WHEN IT TIPPED OVER MOVING IT ONE DAY. HAD EPOXIED TIMER TO INSIDE OF MOUNT CAUSE BROKE OFF TAB EARS AND SCREW DOWN PAD WHEN IT FELL. WORKED THREE YEARS THIS WAY UNTIL IT WOULDN'T AGITATE ON RINSE CYCLE. USED HOT AIR GUN TO BREAK EPOXY BOND, CLEANED UP AREA, MOUNTED NEW TIMER SWITCH. PUT ON NEW END CAPS, PAINTED A FEW SCRATCHES, AND PUT DOG KIT IN AGITATOR.... Read more
Almond. Includes both left and right hand side.
Ordered a new glide from Appliance Parts. Took me 5 minutes to install new glide. Took longer to remove old glide because, I had to figure how it came out. Read more
Replaced the switch...your videos are great! Five minutes and the job was done..OK,maybe ten,but with no swearing either! Read more
It took two repair attempts to fix the dryer. At first, I noticed that the rear felt seal was completely worn out, so I thought that extra friction between the tub and the rear panel might be causing the motor to have to work too hard and overheat. I ordered a new seal from appliancepartspros.com, and installed it according to their instructional video, but it did not correct the problem. Then I decided that the motor must be going bad, so I watched the on-line video on how to remove the... Read more
When I found the dryer off Craigslist, I didn't notice until recently the front panel plug was missing. I ordered the plug from Appliance Parts Pros, got the part & installation took seconds as it was a snap-in part. Couldn't be any happier. Also discovered the drum would not light up when the door opened. Ordered the bulb also from Appliance Parts Pros. Unplugged the dryer, unscrewed the lens cover, removed the burned bulb, cleaned out the light area, installed the bulb, replugged the... Read more
I opened the top of the dryer (after watching the video on your website) and replaced the lever on the switch. Removed two screws near the lint filter, used a putty knife to release fasteners under the top and raised the top. Held it in place with a short piece of board then removed the two screws holding in the switch and lever. Replaced the broken lever with the new one and put it all back together. The handle was a little more difficult as it took a lot more prying with a screwdriver to... Read more