Maytag Lse7806ace Parts

After some research and some testing with a multimeter, it turned out the lid check switch was bad. Instead of purchasing the entire switch assembly, I purchased just the switch that was bad. The lid switch assembly is easy to disassemble, but requires removing the spring loaded lever to remove the lid cover switch. This is wall current, so make sure you unplug! Installed, test, and everything... still didn't work. When the switch fails it takes the fuse out with it. Since I hadn't ordered... Read more

Unplugged line cord. Removed two phillips screws close to bottom in front and lifted at 30º angle to release top clips on front panel, rotated it aside so as to not disturb door switch wires. Turned drum by hand. Located rattle emanating from blower housing. Removed lint screen and holder with phillips and 1/4" nutdriver. Removed blower housing cover with 1/4" and 5/16" nut driver. Blower wheel's hub was shattered around motor shaft. Ordered new one. Cleaned out lint buildup. Took off... Read more

Ordered my replacement unit from APP, along with a few other "while I am fixing this I should replace that since I am disassembling the washer" parts also from APP. After 2 hours of repair work, the washer is back in full working as new order. The only recommendation to others is make sure you order ALL the parts for the job. Take time to investigate all that you will or might need to replace. An ounce of prevention is worth the pound of cure. Like the old line; measure twice and cut... Read more

Used the tool i purchased to remove stubborn brake assembly it worked great Read more

I first replaced the two drive belts and the motor springs. That didn't fix it although they did need replacing. I then replaced the two bearings and the brake assy. The washer runs like new. If you replace the brake assembly, you should also replace the bearings. It will save a tear down later on. The Maytag repairman wanted $600.00 dollars to do the job. I did it for less than $200.00. Read more

• Leaking

Found the wonderful parts diagrams you most generously share online and a couple of YouTube videos . I determined it should be repairable. In my cast the agitator shaft was frozen (rusted) in place. I was very fortunate to have been able to eventually remove it with the use of a lot of BP penetrating oil and heat. Long and short the replacement parts fit perfectly and the washer is running like new. Special thanks to the online support make my repair possible. Read more

Using your video then calling Tina, who researched a part I had that wasn't in video or parts list. She had me send in a picture and researched then called me back. The part was redesigned. She was very helpful. Read more