Mdg17mn Parts

This cable tie secures wiring and the power cord to the appliance chassis to help prevent chafing, pinching, or loose connections. Simple, low-cost part that restores proper wire routing and strain relief. What it does

• Holds wiring and harnesses in place to prevent rubbing against sharp edges
• Helps reduce risk of intermittent power or connector strain caused by loose wires
• Keeps harnesses routed for correct clearance and component access
• Useful during repairs to restore original wire routing and strain relief

• One cable tie (wire harness retainer)

• Safety first: disconnect the appliance from power before inspecting or replacing wiring components
• Remove the damaged or existing retainer and route harnesses to match original OEM routing before installing the new tie
• Trim excess tie tail; do not overtighten—secure, but avoid crushing wires
• Replace any tie that's melted, cracked, or otherwise damaged rather than reusing it

This gas valve assembly controls the flow of gas to the burners or oven, restoring safe and reliable ignition and temperature control. Designed to replace a faulty valve that prevents proper burner or oven operation. What it does:

• Regulates gas flow to the oven and/or surface burners so they ignite and heat as intended
• Stops gas flow when the control signals a shutoff, helping prevent unintended gas delivery
• Commonly used to address no-heat, burners that won't light, or continuous clicking/ignition issues
• Works with the appliance's electrical and thermostat control signals to open and close the valve

• One gas valve assembly (1 piece)

• Turn off gas supply and electrical power before starting any work
• After installation, check all connections for gas leaks and verify proper ignition and operation
• Do not install a damaged part; replace if any fittings, seals, or electrical connectors are compromised

This cycling thermostat (140°F) regulates dryer temperature by opening and closing to control heat cycles, helping maintain consistent drying and prevent overheating. Designed as a direct replacement for the original temperature control component. What it does:

• Opens at the specified temperature to interrupt the heating circuit and cycles the heater on/off
• Helps maintain consistent drum temperature for reliable drying performance
• Can prevent continuous heating that can cause overheating
• Common symptom: dryer heats erratically, runs but doesn't reach proper temperature, or overheats

• Disconnect power to the dryer before inspecting or replacing the thermostat
• Locate the thermostat on the heater assembly/blower housing per your model's service guide
• Replace with the same temperature-rating thermostat and secure all wiring connections
• Test the thermostat for continuity with a multimeter