Mle20000ayw Parts

This hinge kit replaces a worn or damaged refrigerator/freezer door hinge to restore proper door alignment and sealing. It helps stop door sagging and ensures smooth opening and closing for a tight temperature seal. What it does:

• Replaces a damaged or bent door hinge to correct misaligned or sagging doors
• Restores smooth hinge movement for easier opening and closing
• Helps the door seal properly to maintain internal temperature and efficiency
• Prevents rubbing or binding that can damage door gasket or cabinet finish

• Disconnect power to the appliance before beginning any repairs to avoid injury
• Support the door while removing and installing the hinge to prevent dropping or damage
• Use basic hand tools; follow for correct alignment and torque
• After installation, check door alignment and gasket contact; adjust as needed

Spesc: #12 pozi - drive

This vent tube assembly directs exhaust airflow from the dryer to the cabinet exit, restoring proper venting and reducing moisture buildup. It's a direct-fit replacement that helps return your appliance to normal drying performance. What it does:

• Channels hot, moist air from the dryer drum to the exhaust outlet to prevent interior condensation.
• Replaces damaged, crushed, or disconnected tubing that can cause poor drying or longer cycle times.
• Helps reduce lint accumulation at the blower assembly by providing a continuous exhaust path.
• Can resolve symptoms like reduced drying efficiency, excess humidity around the appliance, and unusual airflow noises.

• One vent tube assembly

• Disconnect power (and gas supply if applicable) before starting any repair.
• Access the dryer rear or cabinet per your model's service instructions to remove the old tube and install the new one.
• Ensure the tube is routed without sharp bends or kinks and secure clamps/fasteners tightly to prevent leaks.

Size: 8-32 x 1/4 inch.

Color: White

A small replacement clip that secures the dispenser hose to the dispenser assembly, helping keep the hose seated and reducing the chance of leaks or disconnection. Simple, durable part for restoring proper hose retention. What it does:

• Holds the dispenser/hose connection firmly in place to prevent the hose from slipping free
• Helps reduce water leaks and intermittent dispenser flow caused by a loose hose
• Keeps hose routing stable to avoid rubbing or wear against nearby components
• Works with the dispenser assembly to maintain proper alignment and seal

• One retainer as shown

• Disconnect power and water supply before starting any repair
• Access the dispenser area per your appliance's service instructions; remove trim or panels if required
• Snap the retainer over the hose at the dispenser connection until it seats; verify the hose is fully seated
• If you see damage to the hose or fittings, replace those parts before finishing