Nmws336fs01 Parts

I tore into the washer until i found what i thought was the problem which was the upper outer tub splash cover gasket and when i couldnt find one in my town i ordered a new one from u folks and replaced it hoping for the best and was successful. This fix costed me $35 instead of the $400+ for a new washer glad i looked into it instead of discarding it and buying a new one as most may do thanks Read more

The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off... Read more

Watched a few of your videos and ordered the springs and a insert, and actually got the parts right. I am not a Appliance repair guy but I am retired and I am pretty handy so I thought what the heck. I watched the videos, a lot of common sense, common tools, and plenty of time. My knuckles are busted up and a little blood, but I got it done. Was actually kind of rewarding. Works like a champ. The Videos, ARE AWESOME. Read more

Ordered parts from appliancepartspros.com then saw the video they made on replacing door. Then completed door within 30 minutes. Very easy and fast thanks to parts pros video! Read more

The repair guy told me if I have him fix it I should just buy a new one. I like my washer and dryer because it's a combo and takes up little space so I decided to fix it myself. Not sure if I got lucky but appliance parts pros had a video with almost my exact washer which made repair very easy. Read more

It took less than 5 minutes to fix it. It was very simple, the part fit perfect. I will keep this web site in my favorites for later use. Read more

It took less than 5 minutes to fix it. It was very simple, the part fit perfect. I will keep this web site in my favorites for later use. Read more

I took the front panel off and exposed the mechanism. Inside the shield is a capacitor, so I guessed that the capacitor was bad. I ordered a new shield which contains a new capacitor, installed it, and the washer now works normally again. At first the pump motor made a few clicks before it started running, so I believe the drain pump had an obstruction of some kind inside it, like a bolus of sand, that caused the motor to seize temporarily and burned out the capacitor. It's possible the... Read more

I replaced the Water Level Switch. I ordered it from AppliancePartsPros.com. Installed the switch in (5)minutes. I was able to load my washer to the right water level that I selected. Read more