Whdr626fww Parts

Searched online what could be causing the problem after mopping water for a good 30 minutes. Chatted online with a specialist at Appliance Parts Pros. After trying several things by process of elimination I was advised that the problem was more than likely the water level switch. Ordered the part. It arrived in 2 days. Installed the switch which took less than 10 minutes and now my machine is as good as new. Thank You Appliance Pros. Read more

Ordered water inlet solinoid valve and water temperature probe sensor. Items arrived in a few days. Appliance Parts Pros on-line video was extremely helpful for replacing inlet valve. It only took 20 minutes. Recommend replacing temp. sensor probe while old valve is out before mounting new valve. Only 2 screws-Easy. Entire job took about an hour start to finish. Saved at least $150 doing it myself over repairman and saved $750 over replacing the washer. Happy wife, happy life! Read more

Replaced the timer, and knob Read more

• Won't start

Replaced control board assembly and housing as a unit, since problem likely at the switch or the relay and neither part available to me. Removed original board assembly from housing to inspect, found no visible damage or corrosion Found the correct board configuration by searching the model number online and looking at several websites. The appliancepartspros.com site had the photos to confirm the board configuration, gave the GE part number, sold the board installed in the housing, offered an... Read more

Ordered new timer, dial and control knob assembly. After unplugging machine I removed the knobs from the control consul. Removed three screws holding consul face plate from rear of machine. Moved faceplate forward to gain access to electronic components. Timer is located on right with one hold down screw which I removed. Lifting timer from mount location I removed wiring harness. Installed harness on new times and inserted into hole for knob. It would be helpful if front was market on timer.... Read more

Replaced transmission and brake assembly. The video on appliancepartspros.com was very helpful. A few comments: 1) On my model, there was no wiring harness to unhook to detach the lid switch, as was shown on the video. Instead, I had to remove the switch itself. Underneath, one of the short edges of the switch has a clip that you depress, and then you can poke the switch up. Once it's loose, then you can turn it a bit and work it down through the hole so it's free of the lid. 2) The tub nut may... Read more

Pulled front panel off. Unbolted and removed top cover. Removed tub trim cover. Removed and replaced gasket and dampers. Put it a back together took about 20 minutes Read more