Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Protects the washer's inner drum edge and prevents clothing from snagging on the tub lip. Replace if cracked, broken, or missing to avoid fabric damage.
Usually ships within 4 - 14 days
This washer front panel assembly replaces a cracked, worn, or damaged console face. Restores appearance and provides housing for control buttons.
Dishwasher not powering on or experiencing electrical issues? This terminal block housing insulator protects wire connections. Simple repair part.
Rubber bushing that cushions and protects wires from sharp edges inside your washer. Replace if cracked, worn, or missing to prevent wire damage.
Concrete counterweight that attaches to the washer tub to stabilize the drum during spin cycles. Replace if cracked, broken, or missing pieces.
Mounting screw for dishwashers and washers. Used to secure internal components like pumps or transmissions. Replace if stripped, missing, or broken.
Silicon controlled rectifier (SCR) for washer power control boards. Replace if component is burnt, damaged, or failing to regulate current properly.
Left apron bracket for washers. Secures the apron panel to the washer cabinet. Replace if cracked, broken, or missing to restore proper panel support.
Right side apron bracket for washers. Secures the apron panel to the washer cabinet. Replace if cracked, bent, or broken to restore proper panel support.
Washer leg and platform assembly that supports and levels your washer. Replace if the leg is cracked, broken, or the platform is damaged or missing.
This 1/4-20 screw secures the leg and platform assembly in your top-load washer. Replace missing or loose screws to restore proper balance.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
White right-hand console endcap for dryers. Replaces cracked, broken, or missing endcaps to restore the finished look of your control panel.
Replacement end cap for washer left-side assembly. Secures cabinet alignment and protects internal components. Needed when original is cracked or missing.
Self-leveling bracket for top-load washers. Mounts to the base to stabilize the unit. Replace if broken, bent, or missing to restore proper leveling.
Converts older 3-piece washer support apron to one-piece design. Replaces sagging, bent, or broken apron brackets that cause motor clearance issues.
Following the video instruction. Very easy used putty knife,needle nose plyers and a electric drill driver to remove the sheet metal screws/nuts. Read more
Bushing that supports the washer lid hinge mechanism. Replace if cracked, worn, or causing the lid to sag or close improperly. Direct fit part.