Wmh53520cs-1 Parts

The Microwave Door is an OEM part for Whirlpool microwaves. It provides access to the cooking cavity while also serving to safely contain microwave emissions. Made of glass, the door allows for easy visibility of foods inside without interfering with cooking performance. 

Symptoms of a bad microwave door include:

• Cracks or chips in the glass that could weaken containment
• Difficulty opening or closing the door smoothly 
• Warping or sagging of the door frame over time
• Leaks that allow the escape of microwave radiation 

Causes of a bad door can be repeated stress from opening and closing, accidental damage, or failure of hinges or latching mechanisms. Improper sealing also risks safety. 

It is compatible with kitchen appliances from Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and Kenmore as well.

This complete microwave door assembly replaces a damaged or non-sealing door to restore proper closure, heat containment, and user access. It includes the outer door, inner liner, handle area, and latch interface in one ready-to-install unit. What it does:

• Replaces a cracked, dented, or warped door that won't close or latch properly
• Restores the microwave's ability to contain heat, sparks, and cooking odors
• Re-establishes the door latch engagement so the oven recognizes door-closed status
• Improves user access when original door handle or hinge area is broken

• Turn power off at the breaker and unplug the microwave before servicing
• Some models require partial disassembly of the microwave cabinet to remove and install the door; follow the OEM service manual
• Handle and mounting hardware may be pre-attached; confirm fit before tightening screws

This outer door panel restores a refrigerator door's exterior appearance and structural integrity. It replaces a dented, cracked or rusted outer door surface to make the appliance look and function like new again. What it does:

• Replaces the refrigerator door's external panel to repair visible damage or corrosion
• Restores a smooth, finished exterior and consistent trim alignment
• Helps protect internal components housed in the door from impact and moisture
• Addresses common symptoms like dents, deep scratches, paint chipping or separated outer trim

• Installation typically requires removing the door from the cabinet and transferring hardware (hinges, handle, trim, insulation) from the old door
• Tighten fasteners to manufacturer torque and verify door alignment and swing after installation
• Keep wiring and insulation protected when separating inner and outer door pieces

This wire harness connects the appliance control and components, restoring reliable electrical connections so your appliance powers and controls operate correctly. It replaces a damaged or faulty harness assembly to help stop intermittent power or control issues. What it does:

• Routes power and signal wires between the control board and components
• Reestablishes lost or damaged connections that can cause intermittent or complete loss of function
• Helps eliminate symptoms such as no power to controls, unresponsive buttons, or components not operating
• Prevents shorts and arcing from frayed or exposed wires when installed correctly

• One wire harness assembly

• Disconnect power (and water, if applicable) before starting any repair
• Compare connectors and routing to the original harness; install in the same orientation and secure all retaining clips
• Avoid stretching or pinching wires; ensure terminal connections are fully seated