Wske5260e1 Parts

This part has been discontinued by the manufacturer and is no longer available.

This door switch completes the circuit when a door or access panel closes, allowing normal operation and preventing the appliance from running with the door open. Replaces a worn or failed door-interlock switch to restore reliable door sensing. What it does:

• Detects when the door is closed and signals the appliance control to enable operation
• Prevents runs or cycles when the door is open for safe operation
• Commonly replaced when the appliance won't start or the door fails to register as closed
• Works as the electrical contact point in the door latch/sensing system

• Disconnect power before servicing to avoid shock or injury
• Access may require removing the door panel or control bezel depending on model
• Handle the switch and connectors carefully to avoid bending terminals

This wire tie secures and organizes wiring inside the appliance to help prevent chafing and loose connections. Its 7-7/8 inch length is suited for bundling harnesses and routing cables away from heat and moving parts. What it does:

• Fastens and groups wires or small hoses to keep them neatly routed
• Helps prevent wire chafing, abrasion, and contact with sharp edges
• Reduces the chance of intermittent connections from loose wiring
• Keeps wiring away from moving components to reduce noise and wear

• Disconnect power before servicing the appliance
• Position wiring as needed, insert tie and tighten; avoid over-tightening
• Trim excess tie length flush and secure cut end away from wires
• Replace any damaged wiring insulation and verify routing before restoring power

A small molded mounting support that secures appliance components and reduces movement for stable operation. Fits into existing mounting points to help keep lines, hoses or small assemblies properly positioned. What it does

• Provides a rigid anchor point to stabilize nearby hoses, lines or small assemblies
• Helps prevent chafing and wear by keeping components from rubbing or moving
• Reduces rattle and vibration caused by loose parts under load
• Commonly replaced when the original block cracks, breaks, or no longer holds fasteners securely

• One saddle block mounting support

• Remove power and disconnect water/gas (if applicable) before starting work
• Inspect surrounding fasteners and mounting hardware; replace worn clips or screws as needed
• Typically installs with existing screws or push-fit tabs; verify fit and orientation before final fastening
• If cracked plastic or other damage is present, replace the block to restore secure mounting