Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
Replace your cracked, stripped, or missing dryer control knob. This assembly attaches to the console shaft to restore smooth setting adjustments.
Carries water from home supply to washer inlet valve. Replace if your hose is cracked, worn, leaking, or damaged by pests or age. Restores proper fill.
If your laundry center won't start, cycles stop mid-operation, or controls are unresponsive, the electronic control board likely failed. Moderate difficulty repair.
Gasket sealer adhesive for dryers and laundry appliances. Bonds and seals gaskets during installation or repair. Replace when worn or missing.
8-16 x 3/8 inch screw fastener for dryers. Secures baffles to drum and various internal components. Replace if missing, stripped, or damaged.
Washer lid won't lock or stays locked? This tension spring restores proper locking action. Simple DIY fix when the lid lock clicks or flashes continuously.
I was stunned and amazed that the directions we watched on you tube were spot on. It was a repair that I was able to do myself. I only needed to replace the latch and that fixed the problem, your tech was knowledgeable and the products came right away, thank you for saving me a costly repair bill. Read more
Hardware washer distributes load under fasteners to prevent loosening and reduce vibration. Replace when missing or damaged to restore secure fit.
Watched a video online, the project took about 20 minutes, went well, parts fit good, the video was very helpful in getting the wash machine up and running. Read more
Connect hot and cold water faucets to your washer's inlet valves with this 2-pack of 5-foot fill hoses. Replace aging, cracked, or leaking supply lines.
Purchased water inlet valve and new hot and cold water hoses. Unscrewed about 5 screws that were holding the top of the washer in place then slide the top forward and up. Released the control top it popped off no screws. Disconnected the wires attached and unscrewed 2 screws holding the valve in place the popped that off. Popped in a new valve and repeated the process in reverse. Boom done! Very simple works like new! Read more
Restores proper water flow in your washer. Replace if leaking, cracked, or worn to prevent water damage. Fits factory connection points. Verify fit.
Replacement power cord for laundry centers and washers. Installs at the rear panel to restore electrical connection. Needed when original cord is damaged, frayed, or missing.
Washer won't spin or agitate? A failed drive motor is often the cause. This motor assembly restores drum rotation and agitation for reliable washing.
Replace your cracked, worn, or missing dryer control knob. Installs on the control shaft for easy grip and reliable setting selection.
Machine screw that secures panels, brackets, and components in appliances. Replace when worn, stripped, or missing to restore tight fit and stability.
Fix a washer that won't fill, overfills, or stops mid-cycle with a new water level pressure switch. Restores proper fill control in 30-45 minutes.
FIRST I UNPLUGGED THE WASHER FROM THE WALL SOURCE OF ELECTRICITY!! After assessing the water levels at different settings were very low, I determined the Switch/Sensor was perhaps defective. I first removed the console to access the switch, removed the switch and found the diaphragm mechanism/plunger to be very sticky in terms of its movement. Because it is plastic, I sprayed a very small amount Armor All on it to lubricate it, which did free it up, however when I replaced it and tested the... Read more
Fixes washer that won't select cycles or ignores knob position. This rotary encoder restores precise cycle selection on the control panel. DIY fix.
Seals and secures the outer tub to reduce vibration in top-load washers. Replace if cracked, worn, or causing excessive noise during spin cycles.