Need Help?
Call or text
Some parts shown may not be for your model. To see parts for your model only, select it from "Matching Model Numbers" list on the left.
This 1/4-20 screw secures the leg and platform assembly in your top-load washer. Replace missing or loose screws to restore proper balance.
OK kids, pay attention! This was my second attempt @ this repair. My first repair started leaking right away and had to be re-done about 6 months later. HERE IS THE PROBLEM!. In the video, you'll notice that (while putting it back together) when you put the square hole washer and split-ring over the shaft, they look to land atop the rubber seal, buy when you do this in real life, there is a gap between the seal and the washer. (This gap was close to a 1/4 inch). I THINK that the first time I... Read more
Usually ships within 4 - 14 days
White right-hand console endcap for dryers. Replaces cracked, broken, or missing endcaps to restore the finished look of your control panel.
Replacement end cap for washer left-side assembly. Secures cabinet alignment and protects internal components. Needed when original is cracked or missing.
Self-leveling bracket for top-load washers. Mounts to the base to stabilize the unit. Replace if broken, bent, or missing to restore proper leveling.
Fix a washer that won't spin or agitates weakly with this motor and clutch kit. Solves pulsing motors and failed spin cycles. DIY repair takes 2-3 hours.
Handy Husband took off front of washing machine, unbolted motor then I held motor in place while he bolted on new one.He had to connect new wire harness.One wire was different color..orange instead of white with red stripe.He wrapped old hanging wires to steel bar supporting drum and new wire harness attached to inside where original used to be.He put on the new belt as well since old one was a bit old.He needed a phillips, metric tools..sockets, wrenches, wire cutters,a crimper, pliers and it... Read more
Converts older 3-piece washer support apron to one-piece design. Replaces sagging, bent, or broken apron brackets that cause motor clearance issues.
Following the video instruction. Very easy used putty knife,needle nose plyers and a electric drill driver to remove the sheet metal screws/nuts. Read more
Secure metal rivets for mounting dryer components. Replace broken, missing, or corroded rivets to properly fasten panels and structural parts.
Replace your washer's timer knob if it's cracked, broken, or missing. This control knob attaches to the timer stem and allows cycle selection.
Replace your washer's timer knob if cracked, broken, or missing. This control knob attaches to the timer shaft for cycle selection and operation.
Secures trim, panels, and wiring harnesses in your laundry center to prevent rattling and shifting. Replace when clips crack or lose tension. Confirm fit with your model number.
Replacement insulation foam block for refrigerators. Installs inside cabinet walls to maintain temperature efficiency. Order when original is missing, damaged, or compressed from wear.
Air deflector for refrigerator icemaker. Snaps onto the ice stripper to direct airflow. Replace if cracked, broken, or missing from your freezer.
Secure solenoid clip for refrigerators. Replace if damaged, loose, or missing to ensure proper solenoid function. Confirm fit with your model number.
Mounting screws, nuts, and washers for washers and washer dryer combos. Replaces missing, stripped, or damaged hardware during installation or repair.