Downdraft Vent Parts

This flexible replacement hose routes water inside the appliance to restore proper water flow and prevent leaks. Built to match the original shape and connections for a direct-fit repair when the original hose is damaged. What it does:

• Transfers water between internal components to enable normal operation
• Prevents leaks caused by cracks, splits or worn material
• Helps stop intermittent or reduced water flow when the original hose is compromised
• Restores secure connections at existing fittings when installed correctly

• One replacement hose

• Disconnect power and shut off the water supply before starting the repair
• Inspect matching fittings and clamps; reuse only compatible hardware or replace as needed
• Seat hose fully on fittings and secure with appropriate clamps to prevent leaks
• After installation, restore power/water and run a short cycle while checking for leaks

This replacement vent directs and controls airflow inside the appliance to restore proper ventilation and help maintain performance. Fits where the original vent is cracked, clogged, or damaged. What it does:

• Channels air through the appliance to support normal airflow and operation
• Helps prevent airflow restrictions that can cause poor performance or overheating
• Replaces damaged, broken, or warped vents that no longer seat or seal properly
• Suitable when original vent shows visible damage, cracking, or warping

• One vent

• Basic hand tools typically required; for access instructions
• Disconnect power (and water, if applicable) before beginning any service
• Handle plastic parts gently to avoid cracking; ensure vent seats evenly and secures to mounting points

This upper duct directs exhaust and airflow inside the appliance to help proper ventilation and heat management. It replaces a damaged or warped upper duct to restore correct internal airflow paths. What it does:

• Channels exhaust and internal airflow between the cooktop/vent area and the vent housing
• Restores proper airflow if the original duct is cracked, bent, or blocking ventilation
• Helps reduce unusual smells or cooking smoke reaching cabinetry by maintaining the exhaust path
• Works as a structural guide for adjacent panels and components in the vent area

• Follow the appliance service manual for disassembly steps and correct reinstallation order
• Disconnect power (and gas if applicable) before servicing to avoid shock or injury
• Use appropriate hand tools; avoid overtightening fasteners that can crack the duct or mounting tabs

This flapper vent is the replacement exhaust flap that helps control dryer airflow and keeps outside air, pests and debris from entering the vent when the dryer is off. Fits many GE dryer exhaust housings. What it does

• Opens during dryer operation to let moist air escape and closes when the dryer is off to block backdrafts.
• Restores proper airflow when a damaged or stuck flap is preventing venting.
• Helps reduce outside odors, drafts and pest entry through the exhaust opening.
• Works as a simple mechanical replacement—no electrical connections.

• Disconnect the dryer from power and, if applicable, turn off gas before servicing.
• Access the exterior vent or the dryer exhaust housing; replacement typically secures with screws or snaps into the vent housing.
• Inspect and clean the vent duct and housing before installing the new flap to ensure proper operation.

This pump hose channels washer tub water to the drain pump, restoring proper drainage and preventing leaks at the pump connection. Durable flexible tubing designed to match factory fit and routing. What it does:

• Transfers wash water from the tub to the drain pump for normal draining
• Replaces cracked, collapsed, pinched, or leaking pump hoses that cause poor drainage
• Helps stop leaks that can occur where the tub outlet connects to the pump
• Restores reliable water flow when the original hose is brittle or damaged

• Disconnect power and water before installing; follow all safety precautions
• Inspect clamps and surrounding fittings; replace clamps if damaged or corroded
• Ensure proper routing and secure clamps to avoid kinks or contact with moving parts
• Test a short cycle after installation to check for leaks