Your search "thermador detergent" did not match any products.

The Circulation Motor and Heater Assembly is an OEM part for Bosch dishwashers. It includes both the circulation motor, responsible for moving water through the dishwasher during the cleaning cycle, and the integrated heater, which raises the water temperature for effective cleaning and drying.

Symptoms of a bad Circulation Motor and Heater Assembly include:

• Dishwasher fails to clean dishes properly
• Water does not heat up, leading to poor drying results
• Unusual noises during the cycle 

A bad part can result from several causes, such as electrical failures, mechanical wear and tear, or blockages in the system that prevent proper water circulation or heating. 

If you notice any of these signs, it's time to replace the circulation motor and heater assembly. This OEM Bosch part can also be used on Thermador and Gaggenau appliances.
 

The Defrost Thermostat is an OEM part for Whirlpool refrigerators. It is responsible for monitoring the temperature of the evaporator coils. When the coils reach a certain temperature, the thermostat signals the defrost heater to turn on and melt any ice or frost buildup. This ensures proper airflow and prevents excessive ice formation.

Causes of a bad defrost thermostat can be attributed to normal wear and tear over time or electrical malfunctions.  

Symptoms of a bad defrost thermostat include:

• Excessive ice buildup in the freezer section.
• Inadequate cooling in the refrigerator compartment.
• Frost or ice accumulating on the evaporator coils.

This OEM Whirlpool part can also be used on Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore/Sears brand appliances.

This replacement sealing gasket restores a tight, leak-resistant barrier between mating components in your appliance. Replacing a worn seal helps prevent leaks and moisture escape to keep performance stable and reliable.

• Maintains a watertight/airtight seal between connected parts
• Helps resolve leaks, drips, and moisture pooling inside or beneath the unit
• Addresses issues caused by flattened, cracked, or hardened seals
• Supports proper operation by preserving pressure and flow at the joint

• Disconnect power and, if applicable, shut off water before servicing
• Remove the related cover/assembly to access the old seal; note its orientation
• Clean the groove/mating surfaces; install the new seal evenly without stretching
• Reassemble and run a short test to check for leaks