Rd50cbmo Parts

This replacement screw secures appliance panels and components so they stay tight and aligned during use. Replacing a missing or damaged screw restores a solid fit and helps eliminate rattles, loose trim, or shifting parts.

• Fastens brackets, panels, trim, or components to the appliance chassis
• Helps correct loose or missing hardware after vibration or service
• Replaces stripped, rusted, or broken screws
• Can reduce rattling noises or misaligned parts caused by missing fasteners

• Disconnect power; for gas appliances, also shut off the gas supply
• Support the part being fastened; start threads by hand to avoid cross-threading
• Use the correct driver size; tighten snugly without overtightening
• Replace hardware with the exact part number to ensure proper fit

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This is a genuine lock nut replacement. This is a general piece of hardware that is often used on several types of lawn and garden equipment, including in engines, housing, and other areas. The exact application of this part will vary based on the unit. The lock nut is used to create a more secure seal than a standard nut. When properly secured, the lock nut tightens to a bolt and uses an extra locking washer with teeth to ensure a snug fit.If lock washers do get damaged or lost, they need to be replaced immediately with a genuine OEM replacement. This model is compatible with all types of machines and units since it is a generic part. The washer is sold as an individual part and manufactured by Whirlpool. Lock nuts will need to be installed using a socket wrench or adjustable wrench. Pliers, a screwdriver, or another socket wrench will be needed to hold the bolt while the lock nut is being secured in place. Be sure to thread the lock nut carefully to ensure a strong seal and avoid stripping the bolt or the nut.

Size: 5/16 inch.

Size: 3/8 inch.

Size: 3/4 inch.

Size: 1/4 inch.

This water level pressure switch senses tub water height and tells the washer control when to stop filling for correct load levels. Replaces a failed or intermittent pressure sensor to restore proper fill control and cycle operation. What it does

• Detects water level changes via air pressure from the drain/tub to signal the control board.
• Stops filling when the correct water level is reached to prevent overfill.
• Resolves symptoms like overfilling, underfilling, or washer that won't advance cycles when caused by a faulty switch.
• Works with the washer's control system—does not include hoses or wiring harness.

• One water level pressure switch (one complete switch assembly).

• Disconnect power and turn off the water supply before replacing the switch.
• Verify location and routing of the pressure hose; replace any cracked or collapsed hose that can cause false readings.
• Handle electrical connectors and the pressure port carefully—avoid pulling wires or forcing tabs.
• Test operation after installation by running a fill/drain cycle and observing fill level.