Parts for Lg LW1800PR / AWY6USL: Section 1 Parts

This replacement electric capacitor helps stabilize voltage for appliance motors and control circuits, restoring reliable starts and smoother operation. Use it to replace a worn or failed capacitor to address motor-related performance issues. What it does:

• Stores and releases electrical charge to help motors start and run smoothly
• Stabilizes voltage to reduce surges that can affect control circuits
• Common symptom: motor hums but won't start or runs weakly
• Common symptom: intermittent operation or frequent tripping of breakers/fuses
• Can fail over time from heat, age, or repeated starts

• Always disconnect power to the appliance before servicing
• Discharge capacitor terminals before touching to avoid shock
• Observe terminal orientation and wiring; replace with identical type/ratings

This air cleaner filter assembly replaces the refrigerator's air filtration module to help keep interior air fresher and reduce common food odors. It restores the filter housing and sealing surface so the filtration element works as intended. What it does:

• Holds and seals the refrigerator air filter cartridge to direct airflow through the filter media
• Helps capture food odors and airborne particulates inside the fresh food compartment
• Restores proper fit when a damaged or missing housing causes bypass or poor sealing
• Supports normal airflow for the fridge's air circulation system

• Unplug the appliance or disconnect power before servicing
• Locate the filter assembly per your owner's manual; remove the old assembly before installing the replacement
• Verify the filter cartridge seats fully and the housing gasket compresses for a proper seal

This NTC thermistor assembly senses temperature and sends readings to the control board so the appliance maintains the correct cooling cycle. It replaces a failed or intermittent temperature sensor to restore proper temperature regulation. What it does:

• Measures compartment temperature and relays the signal to the control board
• Helps the appliance decide when to run compressor and fans for stable cooling
• Commonly replaces units that cause incorrect temperature readouts, excessive frost, or compressor cycling
• Works as the OEM temperature-sensing element in the appliance's refrigeration system

• Disconnect power before accessing internal components to avoid shock
• Handle sensor and wiring gently; avoid bending or crimping the thermistor tip
• Verify connector seating and routing to prevent pinched wires or interference with moving parts

This axial fan assembly moves air through the appliance to help maintain proper cooling and airflow. Replaces a worn or failed fan to restore ventilation and reduce excessive heat or frost buildup. What it does:

• Circulates air across coils or components to support normal cooling performance
• Helps prevent overheating of condenser or compressor areas
• Stops or slows if blades are obstructed, bearings fail, or motor windings wear
• Causes increased noise or vibration when worn

• Disconnect power to the appliance before starting any repair
• Handle fan blades carefully to avoid damage and sharp edges
• Verify fan spins freely by hand before full reassembly
• Use correct mounting hardware and wiring connections; service guide if needed