Parts for Frigidaire RS249NCD0: 07 - Shelves And Supports Parts

This factory fastener secures appliance panels and components. Replace a missing, stripped, or corroded screw to restore a tight, rattle-free fit and keep brackets and covers properly aligned.

• Fastens panels, brackets, and internal parts as specified by the manufacturer
• Helps maintain alignment and reduces vibration/rattling
• Replace if the head is stripped, threads are damaged, or corrosion is present
• Symptoms include loose/missing hardware, gaps, or rattling during operation

• Disconnect power; shut off gas/water if applicable before servicing
• Use the correct driver/bit size to avoid stripping the head
• Start threads by hand to prevent cross-threading; do not overtighten
• Match screw length/thread to the location; replace in sets when required

This part has been discontinued by the manufacturer and is no longer available.

This screw fastener secures appliance panels and small components to restore proper fit and reduce vibration. It's a direct-replacement OEM-style fastener used where factory screws are required. What it does:

• Secures trim, panels, or brackets to prevent rattling and misalignment
• Replaces missing or damaged screws that allow parts to shift or vibrate
• Restores stable mounting for controls, housings, and interior components
• Helps maintain proper gaps and seals when fastening exterior or interior pieces

• One screw fastener

• Unplug the appliance or disconnect power before starting any repair
• Use the correct screwdriver or bit to avoid stripping the head
• Install by hand initially, then snug—do not overtighten to avoid damaging threads or parts
• If original screw is corroded or broken, compare head type and length to ensure correct fit

1/4"diameter - 93" long, plastic, cut-to fit

This is a hanger-mount screw used to secure interior refrigerator components such as deli/meat pan hangers and shelf supports. It provides a simple replacement to restore secure mounting and proper shelf alignment. What it does:

• Secures hanger mounts or support brackets that hold deli/meat pans or shelves in place
• Replaces missing or stripped screws that cause loose or sagging shelves
• Restores proper fit so stored items sit level and components do not shift
• Works where a #8 x 1/2 in pan-head fastener is specified

• One screw

• Disconnect power or unplug the appliance before performing any service
• Use the correct sized screwdriver to avoid stripping the pan head
• Thread carefully and tighten until snug; do not overtighten to prevent damage to the mounting surface