Parts for Thermador PRD486GDHC/07: Small Oven Parts

The Lamp is an OEM part for Bosch ovens and ranges. It illuminates the oven cavity, allowing users to easily monitor food placement and cooking progress without disrupting the temperature and climate inside. Proper lighting aids in achieving optimal bake and broil results.

Causes of a bad oven lamp can include burnt out or broken bulbs due to age, high heat exposure, or accidental breakage.

Symptoms of a bad oven lamp include:

• Dim or flickering light from the bulb
• Premature failure of the light source
• Faulty or loose electrical connections
• Physical damage to the lamp housing or lens

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This heating element heats the dishwasher tub to help dry dishes and support wash cycles that require elevated water temperatures. It replaces a failed or damaged tub heater to restore normal wash and dry performance. What it does:

• Heats water and helps evaporate moisture during the dry phase
• Supports high-temperature wash cycles for better cleaning
• Can resolve symptoms like poor drying, lukewarm wash water, or heater-failure error codes
• Works as the electrical heating component mounted near the dishwasher tub

• Disconnect power at the breaker before any service to avoid shock risk
• Access may require removing the lower kick plate or tub panels; handle the element and surrounding wiring carefully
• Verify connections and grounding are secure; inspect wiring and terminals for damage
• Follow the dishwasher's service manual or OEM instructions for correct removal and replacement

The temperature sensor is an electronic probe that monitors internal appliance temperature and reports it to the control so it can regulate operation. Replacing a failed sensor restores more accurate temperatures and can clear temperature-related error codes. What it does:

• Senses internal temperature via resistance changes and sends the signal to the electronic control
• Helps the control reach and maintain the set temperature during operation
• Common failure symptoms: too hot/cold, won't reach set temp, long/short cycles, temperature error codes
• Can cause preheat to stall or the unit to shut off early (model dependent)

• Includes: 1 temperature sensor

• Disconnect power at the breaker before servicing
• Location and access vary by model; typically mounts with screws or a clip and connects to a 2-wire harness
• Handle the connector and wiring carefully; route and secure away from hot or moving parts
• After installation, clear stored errors and run a test cycle to proper readings