Parts for Thermador CMT131: Switches & Additional Parts

This switch bracket secures the appliance switch in place, restoring reliable switch alignment and operation. It provides a durable mounting point so switches engage correctly and deliver consistent control. What it does:

• Holds the electrical/mechanical switch in the correct position for reliable actuation
• Helps stop intermittent or failed switch contact caused by loose or damaged mounting
• Supports proper panel or door alignment where the switch interfaces
• Prevents further wear on switch terminals by stabilizing the switch housing

• Disconnect power before beginning any work to avoid electric shock
• Basic hand tools are typically required; retain any original fasteners unless replacing them
• Verify switch alignment and operation after installation; adjust bracket position as needed
• If switch or wiring shows damage, replace or repair those components per OEM guidance

This is a replacement LIS CMT switch used to restore proper electrical switching for the control module and motor circuits. It helps return normal operation when the original switch is worn or failed. What it does:

• Acts as an electrical switch for the control module and motor circuitry
• Enables the appliance to complete control signals needed for motor or control functions
• Commonly linked to symptoms like no motor response, intermittent operation, or unresponsive controls
• Provides a direct replacement that fits the original mounting and connector arrangement

• Disconnect power to the appliance before attempting any repairs to avoid shock
• Handle the switch and connectors carefully to avoid damage to terminals or wiring
• Verify connector orientation and secure mounting when installing the new switch

This LIS switch (CMT) is a direct-replacement electrical switch that restores reliable circuit signaling for the appliance control system, helping return proper operation to affected functions. Designed to fit the original mounting and connector layout. What it does:

• Acts as the LIS (logic/interlock/signal) switch that opens or closes an electrical circuit when actuated.
• Restores reliable communication between the door/control assembly and the appliance control board.
• Commonly used to address symptoms such as intermittent operation, failure to start, or unresponsive controls.
• Matches OEM form and connector style for a straightforward replacement.

• Disconnect power (unplug or switch off breaker) before attempting any repair.
• Use basic hand tools; note connector orientation before removal to ensure correct reinstallation.
• Handle the switch and wiring harness carefully to avoid damage to terminals or insulation.

This hinge stop secures and limits door movement for proper alignment and safe operation, helping prevent over-travel and wear on the hinge assembly. It's a direct-fit replacement designed to restore correct door stopping action. What it does

• Acts as the mechanical stop that limits door swing to the intended opening angle.
• Restores proper door alignment when the hinge no longer catches or the door swings too far.
• Helps reduce stress and wear on hinge pins and mounting points.
• Common symptom: door drifts past the closed/stop position or hangs unevenly.

• One hinge stop

• Disconnect power to the appliance before starting work when applicable.
• Access may require removing door trim or covers; keep fasteners organized.
• Use basic hand tools; avoid forcing components to prevent damage.