Parts for Jenn-Air PRD3030NP: 08 - Top / Burner Valves Parts

This reignition module controls and directs the spark to a cooktop's surface burners so they ignite reliably and re-spark if a flame goes out. It restores burner ignition performance and reduces persistent sparking. What it does:

• Sends high-voltage spark to the burner ignitors to light the gas flow
• Attempts automatic re-ignition when a flame is extinguished (safe, intermittent sparking)
• Stops sending spark when the burner control is off
• Commonly linked to symptoms like burners not lighting, constant clicking, or no spark at ignition

• Turn off electrical power and gas supply before servicing.
• Handle wiring and connector pins carefully; match connectors to avoid miswiring.
• Follow OEM instructions for removal and replacement.

This burner valve controls gas flow to the oven/burner, restoring proper ignition and flame control when the valve fails. It replaces a worn or leaking valve to improve burner performance and safety. What it does:

• Regulates gas supply to the burner so the flame ignites and maintains correctly
• Commonly replaced when burners won't light, have weak or uneven flames, or shut off unexpectedly
• Stops or reduces gas leakage from a faulty valve when operating normally
• Works as the mechanical control actuated by the appliance's control system to start/stop fuel flow

• One burner valve

• Turn off gas supply and electrical power to the appliance before beginning any repair
• Replace with the exact part and tighten fittings per manufacturer torque guidelines to prevent leaks
• After installation, check all connections for leaks using a safe leak-detection method (soapy water test or approved detector)

A replacement igniter switch that restores spark control for gas ranges and ovens so burners or the oven igniter can light reliably. Designed to replace a faulty spark switch and help resolve intermittent or absent ignition. What it does:

• Sends the ignition/spark signal to the appliance's igniter or spark electrode.
• Commonly replaces a switch that causes clicking without ignition or burners that won't light.
• Works as the electrical control point between the user controls and the igniter circuit.

• Disconnect power to the appliance and shut off gas supply before beginning any repair.
• Note wiring locations or take a photo, then remove and reconnect wires one at a time to ensure correct placement.
• Wear safety gloves and follow all appliance-specific instructions from the manufacturer.