Parts for DE62T27DW1-96126A: Top Deck / Electronics Parts

This is a stainless steel #8 x 5/8" Phillips screw sold in a pack of 10 — a direct-fit fastener for appliance panels, brackets, and trim. Durable corrosion resistance helps maintain secure assemblies over time. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components using a Phillips driver
• Stainless finish resists rust and corrosion in humid or wet appliance areas
• Sized for common appliance mounting points where #8 x 5/8" screws are specified
• Helps restore loose or missing fasteners that cause rattling or poorly seated panels

• Ten (10) stainless steel #8 x 5/8" Phillips screws

• Use the correct #2 Phillips bit and moderate torque to avoid stripping the head or damaging mating parts
• Tighten until snug; do not overtighten plastic components
• Disconnect power to the appliance before accessing internal panels or wiring
• Keep loose screws away from children and dispose of packaging responsibly

This touch control panel is the user interface assembly with integrated LED feedback that lets you select cycles and options on your washer or dryer. It replaces a worn, cracked, or unresponsive front control surface to restore normal operation. What it does:

• Registers touch commands for cycle and option selection so the appliance responds correctly to user input
• Provides LED indications for selected settings and cycle status
• Replaces cracked, faded, or cosmetically damaged control surfaces
• Can resolve issues where touchkeys are unresponsive or LEDs fail to illuminate

• Disconnect power to the appliance before any disassembly to avoid shock or injury
• Handle the panel and LED window carefully to avoid scratching or cracking glass/plastic
• Installation typically requires removing the console or front panel and unplugging the old panel connector(s)

The Lid Assembly is an OEM part for Fisher & Paykel dryers. It consists of the dryer lid and attached hinges, which provide controlled access to the drying chamber.

Symptoms of a bad lid assembly include:

• Difficulty opening or closing the dryer lid
• Loose, unstable, or off-track movement of the lid
• Gaps in the lid seal letting heated air escape

Causes of failure can be stripped or worn-out hinges, broken seals or cracked plastic over prolonged use. Overloading the dryer can also put excess stress on the lid assembly.