Parts for DG62TGW1-96142A: Top Deck / Electronics Parts

This is a stainless steel #8 x 5/8" Phillips screw sold in a pack of 10 — a direct-fit fastener for appliance panels, brackets, and trim. Durable corrosion resistance helps maintain secure assemblies over time. What it does:

• Fastens panels, brackets, trim pieces, and other appliance components using a Phillips driver
• Stainless finish resists rust and corrosion in humid or wet appliance areas
• Sized for common appliance mounting points where #8 x 5/8" screws are specified
• Helps restore loose or missing fasteners that cause rattling or poorly seated panels

• Ten (10) stainless steel #8 x 5/8" Phillips screws

• Use the correct #2 Phillips bit and moderate torque to avoid stripping the head or damaging mating parts
• Tighten until snug; do not overtighten plastic components
• Disconnect power to the appliance before accessing internal panels or wiring
• Keep loose screws away from children and dispose of packaging responsibly

This display kit replaces a failed dryer control display so you can see and select drying cycles and settings. It restores visible status feedback and allows normal control-panel operation for troubleshooting or repair. What it does:

• Replaces the dryer's front control/display assembly to restore on-screen indicators and control input response
• Makes cycle status, temperature, and timer information readable again
• Helps resolve symptoms such as blank or non-responsive display, missing indicators, or unreadable characters
• Works with the existing control harness and front console so normal button presses register correctly

• Disconnect power before servicing to avoid electrical shock and damage
• Remove the dryer top or front panel per service manual to access the display assembly
• Handle the display carefully to avoid scratching or bending the panel and ribbon connectors

The Lid Assembly is an OEM part for Fisher & Paykel dryers. It consists of the dryer lid and attached hinges, which provide controlled access to the drying chamber.

Symptoms of a bad lid assembly include:

• Difficulty opening or closing the dryer lid
• Loose, unstable, or off-track movement of the lid
• Gaps in the lid seal letting heated air escape

Causes of failure can be stripped or worn-out hinges, broken seals or cracked plastic over prolonged use. Overloading the dryer can also put excess stress on the lid assembly.