Parts for Ge RE2H80R6-1NCWW: Unit Parts

Mounting screw for water heater component installation. Replace if screw is stripped, corroded, missing, or threads are damaged during maintenance.

This compressor overload protector helps shut off a refrigerator compressor when electrical overload or heat risks occur, protecting the compressor from damage and keeping the cooling system more reliable. What it does:

• Interrupts compressor current during overheating or electrical overload to prevent motor damage.
• Works with the compressor start device/relay to allow proper motor start and run behavior.
• Common symptom linkage: refrigerator not cooling and compressor runs hot, hums, or cycles rapidly.
• Common symptom linkage: compressor will not start but attempts to run or clicks.

• One compressor overload protector.

• Disconnect power to the appliance before inspecting or replacing the overload; follow all safety precautions.
• Handle terminals gently and install in the same orientation; ensure secure electrical connections and proper seating on the compressor.
• If the compressor or start relay shows other damage, inspect the entire start device assembly and wiring; replace any damaged components before restoring power.

This mastic thermal sensor detects oven temperature and helps the control board monitor and regulate heat for safe, consistent cooking. It's a direct-replacement temperature sensing element used where a mastic-mounted sensor is required. What it does:

• Senses appliance temperature and sends a signal to the control module for temperature regulation
• Helps prevent overheating by allowing the control to reduce heat when temperatures exceed set points
• Commonly replaced when an oven runs too hot, won't reach set temperature, or shows temperature-related errors
• Designed for mastic- or adhesive-style mounting to maintain stable thermal contact

• Disconnect power to the appliance before starting any repair to avoid shock or injury
• Handle the sensor and lead wires carefully; avoid kinking or stressing the sensing element
• Install in the same orientation and mounting location as the original to ensure proper temperature readings

If your water heater is overheating or shutting down unexpectedly, a damaged fan blade may be preventing proper ventilation. This part restores airflow.

Rubber grommet that mounts and cushions the compressor on your refrigerator or freezer. Replace if cracked, worn, or causing vibration noise from unit.

Wire tie retainer for refrigerators. Secures and organizes internal wiring. Replace if cracked, broken, or missing to keep wires properly bundled.