Parts for Gladiator GAFZ30FDGB00: Unit Parts

This start device is the compressor start relay that helps the refrigerator compressor start reliably so the appliance can cool properly. It replaces a failed relay to restore normal compressor startup behavior. What it does:

• Provides the initial electrical boost to the compressor motor during startup
• Helps the compressor overcome inertia so the refrigeration cycle can begin
• Commonly used when a compressor hums or won't start but power is present
• Addresses symptoms such as no cooling, frequent clicking from the compressor area, or a compressor that runs briefly then stops

• One (1) start device / compressor start relay

• Disconnect power to the appliance before accessing electrical components
• Replace only with the correct part number or direct OEM equivalent
• Inspect compressor terminals and wiring for heat damage; replace damaged wiring as needed

This rubber grommet provides a tidy, protective seal where hoses, wires, or shafts pass through the appliance cabinet—helping prevent chafing, reduce vibration noise, and maintain proper sealing around openings. What it does:

• Cushions and protects wiring or hoses from rubbing against metal edges
• Helps maintain a seal to reduce water or air bypass where fitted
• Dampens vibration and reduces related noise at the penetration point
• Keeps openings finished and helps prevent further component wear

• Disconnect power (and water for washers) before starting any repair
• Inspect the mounting area for sharp edges or damage; replace if surrounding parts are compromised
• Push the grommet into the opening and seat evenly; do not stretch excessively