Parts for Jenn-Air JUBFR242HM01: Unit Parts

This control box PCB assembly replaces the oven/dryer/dishwasher electronic control module that manages user inputs and key appliance functions. Restores reliable control signals and helps return responsive operation when the original control fails. What it does:

• Houses the printed circuit board that processes user commands and controls cycles, heater/timer functions, or motor relays depending on model
• Re-establishes power distribution and board-level switching when the previous control malfunctions
• Commonly used when symptoms include unresponsive controls, intermittent operation, or error codes related to the control board
• Works with corresponding wiring harnesses and connectors to interface with the appliance's main components

• One control box PCB assembly

• Disconnect power to the appliance before attempting any service to avoid shock or damage
• Handle the PCB by its edges and avoid contact with components or connector pins to prevent electrostatic damage
• Verify connector orientation and secure all harnesses; do not force connectors—ensure exact mating alignment

This replacement dryer tube channels heated air from the dryer cabinet to the lint filter/blower and exhaust path, restoring proper airflow and helping the cycle dry clothes efficiently. Use it when the original tube is cracked, crushed, or blocked. What it does

• Directs dryer airflow from the drum/blower chamber to the lint trap and exhaust.
• Helps maintain proper venting to prevent overheating and inefficient drying.
• Reduces air leaks that can cause longer dry times or hot spots.
• Minimizes lint buildup in the cabinet by providing a smooth, routed path for debris to the lint filter.

• One dryer tube

• Disconnect power (and gas supply if applicable) before servicing; ensure the dryer is completely powered off.
• Remove front or rear access panel as required to reach and replace the tube; keep fasteners for reassembly.
• Inspect adjacent seals and clamps; replace any damaged gaskets or worn clamps for a secure fit.
• Use gloves to avoid sharp sheet-metal edges and run a short test cycle to ensure proper airflow and quiet operation.