Parts for Frigidaire RT114LCW7: 04 - Inner Parts

Covers the factory test opening on your refrigerator cabinet or liner. Replace if missing, cracked, or damaged to restore a finished look and seal.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This is a replacement hex nut used to secure appliance components and fasteners. It restores proper fastening where a lost or damaged nut causes loose panels or hardware and helps stop rattling or movement. What it does

• Secures panels, brackets, or components to threaded studs or bolts
• Restores proper tension where a missing or stripped nut allows parts to wobble
• Helps eliminate noise from loose hardware and prevents further wear
• Used wherever a matching-thread nut is specified by the manufacturer

• Confirm thread size and type match the original before installing
• Hand-thread first to avoid cross-threading, then tighten with appropriate tool
• Wear eye protection and disconnect power to appliance if working near electrical components
• Do not overtighten; replace any damaged studs or bolts rather than forcing this nut

Refrigerator not cooling but freezer icing up? The defrost timer controls the defrost cycle. Most DIYers replace it in 5-15 minutes with our video guide.

This part has been discontinued by the manufacturer and is no longer available.

Oven light socket holds the bulb and provides electrical connection for interior lighting. Replace if socket is worn, cracked, or bulb won't stay secure. Verify fit with your model number before ordering.

Illuminates your oven interior so you can monitor cooking without opening the door. Replace when burned out or dimming. Verify fit with your model number.

This part has been discontinued by the manufacturer and is no longer available.

Frost buildup on freezer wall? Defrost thermostat monitors evaporator temperature to prevent ice buildup. DIYers report 15-minute installation fixes issue.

Size: 60 inches x 1 1/4 inch x 1/32 inch. Used to hold the ice and water dispenser cover in place.