Parts for Frigidaire RS229MCF0: 05 - Shelves And Supports Parts

This factory fastener secures appliance panels and components. Replace a missing, stripped, or corroded screw to restore a tight, rattle-free fit and keep brackets and covers properly aligned.

• Fastens panels, brackets, and internal parts as specified by the manufacturer
• Helps maintain alignment and reduces vibration/rattling
• Replace if the head is stripped, threads are damaged, or corrosion is present
• Symptoms include loose/missing hardware, gaps, or rattling during operation

• Disconnect power; shut off gas/water if applicable before servicing
• Use the correct driver/bit size to avoid stripping the head
• Start threads by hand to prevent cross-threading; do not overtighten
• Match screw length/thread to the location; replace in sets when required

1/4"diameter - 93" long, plastic, cut-to fit

This is a factory-style replacement screw used to secure appliance components. It restores proper fastening where the original screw is missing, stripped, or damaged so panels and assemblies stay firmly attached. What it does:

• Fastens panels, brackets, or components to the appliance frame or assemblies
• Replaces missing or damaged mounting hardware that can cause rattles or loose parts
• Provides the correct fit and thread engagement for a secure connection
• Helps maintain appliance alignment and safe operation

• Use the matching screwdriver or bit to avoid stripping the head
• Tighten until snug; do not over-torque to prevent thread or part damage
• Turn off power and remove any access panels before working on electrical components

This part has been discontinued by the manufacturer and is no longer available.

This is a hanger-mount screw used to secure interior refrigerator components such as deli/meat pan hangers and shelf supports. It provides a simple replacement to restore secure mounting and proper shelf alignment. What it does:

• Secures hanger mounts or support brackets that hold deli/meat pans or shelves in place
• Replaces missing or stripped screws that cause loose or sagging shelves
• Restores proper fit so stored items sit level and components do not shift
• Works where a #8 x 1/2 in pan-head fastener is specified

• One screw

• Disconnect power or unplug the appliance before performing any service
• Use the correct sized screwdriver to avoid stripping the pan head
• Thread carefully and tighten until snug; do not overtighten to prevent damage to the mounting surface

This rubber grommet cushions and seals appliance components to reduce vibration and prevent wear where wiring, rods or panels pass through mounting openings. It helps keep parts aligned and protects against chafing and noise. What it does:

• Cushions and isolates vibration between moving parts and chassis
• Protects wiring, tubes or rods from rubbing and abrasion at mounting holes
• Helps reduce noise caused by contact or metal-on-metal vibration
• Aids in maintaining proper part alignment and secure fit

• Grommet

• Inspect mating hole and surrounding area for debris or sharp edges before installing
• Fit the grommet into the mounting hole so the flange seats evenly on both sides
• Replace any damaged or excessively worn grommets to restore protection
• Disconnect power and follow appliance safety procedures before attempting service