Parts for Frigidaire RS229MCD3: 02 - Freezer Door Parts

This white end cap is a direct-replacement trim piece that restores the finished edge and keeps the associated rail or trim secure. It provides a clean appearance and helps maintain proper alignment of the assembly. What it does:

• Replaces a cracked, broken, or missing end cap that exposes or destabilizes the rail/trim
• Holds the end of a shelf/rail or trim piece in place to prevent shifting
• Restores the appliance's finished look by covering the exposed edge
• Helps reduce rattles or movement caused by a loose or damaged end cap

• One white end cap

• Basic snap-on or push-in installation; may require a small flat-head screwdriver or trim tool to remove the old cap
• Inspect mating surfaces for damage or debris before installing the new cap
• Handle plastic parts gently to avoid cracking during installation
• Unplug the appliance or disconnect power before doing any service that exposes wiring or components

Replacement part may be longer than needed, per the manufacturer it will have to be cut to fit.

This part has been discontinued by the manufacturer and is no longer available.

This ice door seals the freezer's dispenser chute to keep cold air in and block warm air and moisture out. It helps maintain proper ice dispensing and reduces icing or melting in the dispenser area. What it does:

• Seals the ice dispenser chute to prevent warm air intrusion and reduce ice clumping
• Opens to allow ice to pass when the dispenser is activated and closes to keep the bin insulated
• Helps prevent melted ice or water from entering the freezer cavity
• Reduces noisy or jammed dispensing caused by damaged or misaligned doors

• One ice door

• Disconnect power to the appliance before attempting any repair
• Inspect mounting tabs and hinges for damage; replace if worn to ensure proper sealing
• Handle plastic parts gently to avoid cracking; align door before tightening fasteners

This factory fastener secures appliance panels and components. Replace a missing, stripped, or corroded screw to restore a tight, rattle-free fit and keep brackets and covers properly aligned.

• Fastens panels, brackets, and internal parts as specified by the manufacturer
• Helps maintain alignment and reduces vibration/rattling
• Replace if the head is stripped, threads are damaged, or corrosion is present
• Symptoms include loose/missing hardware, gaps, or rattling during operation

• Disconnect power; shut off gas/water if applicable before servicing
• Use the correct driver/bit size to avoid stripping the head
• Start threads by hand to prevent cross-threading; do not overtighten
• Match screw length/thread to the location; replace in sets when required

Size: Approximate 2.5 inches thick, 33 inches wide and 70 inches long.