Parts for Speed Queen ATGE9ASP115TW01: Wire Harnesses / Wires Parts

This is the upper gas wiring harness for gas laundry appliances — a direct-replacement harness that routes power and control signals to the gas valve and integrated indicator light for reliable ignition and status indication. What it does:

• Connects the appliance control wiring to the upper gas valve and integrated 120V indicator light
• Provides the correct 120V feed and signal path needed for ignition and light operation
• Helps address symptoms like loss of the upper gas valve function or a non-working gas indicator light
• Restores proper electrical continuity where a damaged or burned harness causes intermittent or failed operation

• One upper gas wiring harness with 120V indicator light

• Turn off gas supply and disconnect power before attempting any service
• Verify wiring colors and connector fit before finalizing connections; match harness connectors to the appliance harness
• Inspect related terminals and gas valve for heat damage; replace any damaged components

This pressure sensor harness is the wiring assembly that connects the water-level (pressure) sensor to the washer's control board so the machine can detect and regulate water level properly. Replaces a damaged or worn harness to restore reliable level sensing. What it does:

• Carries the electrical signals between the pressure sensor and control board so the washer reads water level correctly.
• Helps prevent incorrect fills, overfilling, or failure to advance cycles caused by intermittent or open wiring.
• Can stop error codes or faulted cycles related to pressure-sensing circuit faults when the harness is the root cause.
• Maintains secure connector fit and signal integrity compared with frayed or corroded wiring.

• One pressure sensor wiring harness

• Disconnect power to the appliance before starting work to avoid shock or damage.
• Remove access panels as needed and unplug connectors at the pressure sensor and control board; note routing for reinstallation.
• Replace only the failed harness; avoid stretching wires or pinching during re-route and secure with existing clips.