Parts for Thermador H-98: 01 - Hood Parts

This inlet ring is a small sealing/retention part that helps secure the appliance inlet connection and maintain a leak-resistant seal for proper water flow. Use it to restore a tight inlet connection and prevent drips. What it does

• Forms a seal at the appliance inlet to help prevent leaks from the connection.
• Helps hold inlet hoses or fittings securely in place.
• Replace if the existing ring is cracked, flattened, or leaking.
• Can resolve symptoms such as visible dripping at the inlet, loose inlet fittings, or reduced fill performance.

• Turn off water supply and power to the appliance before beginning any work.
• Inspect mating surfaces and replace any damaged hoses or fittings when present.
• Lubricate the ring with a small amount of approved appliance-safe lubricant; avoid petroleum-based products unless specified.
• After installation, restore water and power and check the connection carefully for leaks.

This impeller is the rotating pump component that moves water through the appliance, restoring spray and circulation performance. Replacing a worn or damaged impeller helps resolve poor wash/rinse results and noisy pump operation. What it does:

• Drives water flow inside the pump housing to maintain proper spray and circulation.
• Can cause weak sprays, poor cleaning, or unusual pump noises when worn or broken.
• Fits the CW H98/HB style pump assembly and interfaces with the pump shaft and housing.
• Designed for direct OEM-fit replacement where this impeller is specified.

• Recommended for users comfortable disassembling pump housings; refer to your service manual for specific steps.
• Disconnect power and turn off the water supply before starting service.
• Inspect the pump housing, seals, and shaft for wear; replace any damaged components to prevent repeat failure.
• Use appropriate tools and handle plastic parts carefully to avoid cracking.

This replacement switch knob restores tactile control of a range or oven control shaft, letting you safely set heat and function positions. It replaces a cracked, worn, missing, or hard-to-turn knob to improve usability and safety. What it does:

• Fits onto the appliance control shaft to select temperature or function positions
• Provides a stable grip and clear detent feel for accurate setting changes
• Replaces damaged, loose, stripped, or missing knobs that impede control
• Helps restore normal operation when a knob won't turn or slips on the shaft

• Disconnect power to the appliance before attempting service
• Remove the old knob by pulling it straight off the control shaft; align and push the new knob onto the shaft until seated
• If the old knob is stuck, use a firm, even pull—do not twist or pry aggressively to avoid damaging the control shaft

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

The Range Filter is an OEM part for Bosch range hoods. It is designed to trap grease, smoke, and other airborne particles during cooking, helping to keep the kitchen air clean and preventing buildup on the internal components of the range hood. It measures approximately 10-3/4" x 24-1/2".

Common causes of a bad range filter include accumulation of grease and debris from regular cooking, wear and tear from cleaning, and physical damage such as bends or breaks in the filter material.

Symptoms of a bad range filter include:

• Reduced airflow or ventilation efficiency
• Excessive smoke or odors lingering in the kitchen
• Visible grease buildup on the filter
• The filter appearing damaged or misshapen

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

This part has been discontinued and is no longer available.