Parts for Thermador GCT484GG: 02 - Body & Electrical Parts

This wire harness routes power and signals between an appliance's control and components so the unit operates reliably. It replaces a damaged or faulty harness to restore consistent electrical connections and proper function. What it does:

• Provides factory wiring paths for power and signal connections between controls and components
• Restores intermittent or lost power to accessories caused by frayed or broken wires
• Helps stop arcing, shorts, or error conditions caused by damaged connectors or insulation
• Maintains secure plug-and-socket connections for sensors, switches, and motors

• One complete wire harness as shown

• Disconnect all power before attempting replacement to avoid shock or damage
• Note connector locations before removal; route the new harness the same way to avoid pinched wires
• Use basic hand tools and secure fasteners/clips; do not overtighten

This gas pressure regulator controls and stabilizes incoming supply pressure to the appliance manifold, helping ensure consistent burner flames and reliable ignition. Replace if the original regulator is sticking or no longer maintaining correct pressure.

• Regulates incoming gas to the appliance's rated manifold pressure
• Helps maintain even flame height and proper combustion
• Supports reliable burner ignition and reduces flame-out from pressure swings
• Common symptoms include weak or uneven flames, yellow tipping, burners not lighting or not staying lit, or flames that are too high

• Disconnect electrical power and shut off the gas supply before servicing
• Observe the flow-direction arrow; install with outlet toward the appliance manifold
• Use approved gas-rated thread sealant on male threads only and leak-test all joints with a non-corrosive solution after installation