Parts for Thermador SGCV36: 04 - 30 Inch Gas Controls Parts

Ignition device creates the spark that lights gas burners on compatible Bosch gas ranges and cooktops. Replacing a worn or faulty ignition device restores reliable ignition and reduces burner-start failures. What it does:

• Generates the high-voltage spark used to ignite gas at the burner
• Replaces a unit that causes clicking without ignition or burners that won't light
• Supports reliable ignition timing for proper burner start-up
• Works as the primary spark source for the cooktop's gas ignition system

• Disconnect electrical power and shut off the gas supply before starting work
• Handle ceramic electrodes and connectors carefully to avoid damage
• Basic hand tools are typically required; wiring plugs into the existing harness

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Not Available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Not Available.

This is a replacement mounting screw designed to secure appliance panels and internal components, restoring proper fit and reducing vibration or rattling. Use to replace missing or damaged fasteners for a secure repair. What it does:

• Secures panels, brackets, or internal assemblies to prevent movement
• Restores proper alignment and reduces vibration or noise from loose parts
• Helps maintain electrical and mechanical connections by holding components in place
• Common symptom: loose or missing screw causing rattling, misaligned panels, or parts that shift during operation

• Screw as shown

• Disconnect power to the appliance before handling internal parts
• Use the correct screwdriver or bit to avoid stripping the head
• Thread carefully and do not overtighten to prevent damage to mounting surfaces
• Keep small parts away from children and dispose of damaged fasteners

This part has been discontinued by the manufacturer and is no longer available.

This is a replacement spark module wire used to connect a gas appliance's spark module to an electrode, restoring reliable ignition and consistent spark delivery. Designed as a direct-fit service part where listed. What it does:

• Transfers high-voltage spark from the ignition module to the burner electrode for reliable ignition.
• Replaces cracked, frayed or damaged wiring that causes weak or no spark at the burner.
• Helps resolve intermittent ignition, click-no-light, or spark-arc issues when the module and electrode are functioning.
• Maintains proper routing and insulation to prevent shorting or arcing to adjacent metal parts.

• Always disconnect power and, for gas appliances, shut off the gas supply before starting work.
• Handle the high-voltage wire by the insulated boot; avoid pulling on the conductor or bending the terminal excessively.
• Verify correct wire routing and secure connections to prevent contact with sharp edges or hot components.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.