Parts for Thermador PB30YS: 05 - Burner & Electrode Spark Parts

Replacement 1/4-20 x 1/2 stainless steel bolt that secures appliance components and restores proper fit. Use when mounting hardware is missing, corroded, or loose to stop rattling and maintain alignment. What it does:

• Fastens panels, brackets and other appliance components to prevent movement and vibration
• Replaces missing, stripped, or corroded bolts that can cause loose parts or noise
• 1/4-20 thread with 1/2" length for applications requiring that fit (per part listing)
• Stainless steel construction helps resist corrosion in humid or wet areas

• Disconnect power and water (if applicable) and remove outer panels before servicing for safety
• Start threads by hand to avoid cross-threading, then tighten with the proper wrench or socket
• Do not overtighten; snug until secure and follow manufacturer torque specs if available

A hex keps nut (1/4-20) — a hex nut with an integrated locking washer — provides a secure, vibration-resistant fastening for appliance assemblies; stainless steel construction helps resist corrosion in wet or humid areas. What it does:

• Provides a locking nut solution for 1/4-20 bolts and studs; replaces stripped or damaged nuts to restore a secure connection.
• Integrated keps (locking) washer helps prevent loosening from vibration — useful when panels, brackets, or components wobble or rattle.
• Stainless steel material resists rust and corrosion in damp or high-humidity locations.
• Ideal for replacing missing or corroded hardware during repairs or reassembly.

• Use the correct size socket or wrench; tighten to the appliance manufacturer's specified torque where available and avoid overtightening.
• Disconnect power and shut off water supply when working near electrical or plumbing components.
• Inspect mating threads and replace damaged studs or bolts before installing this nut to ensure a proper, long-lasting fit.

This radiant surface element heats a cooking zone beneath a ceramic-glass cooktop. Replace a failed element to restore consistent, controllable heat when a burner no longer heats correctly.

• Converts electrical energy into radiant heat for its designated burner zone under the glass top
• Works with the control to cycle heat and maintain the selected temperature
• Typical symptoms when failed: burner will not heat, heats unevenly or only partially, or takes much longer to reach temperature
• Visible damage or hot spots beneath the glass can also indicate a failed element

• Disconnect power at the breaker and allow the cooktop to cool completely
• Lift/remove the cooktop glass to access the element; support the glass to avoid stress or cracks
• Transfer wires from the old element to the new one one-by-one; reuse existing brackets/clips if serviceable
• Seat the element flat and centered; avoid touching the coil surface; reassemble and test operation

Color: black. It measures about 5 inches wide by 21 inches deep.