Parts for Amana SZDE20ML / P1120301W L: 05 - Evap And Air Handling Parts

Loose panels or rattling components? This mounting screw secures body panels and electronics in appliances. Quick 5-minute fix for most models.

8-32 x .312 inch mounting screw for washers. Replaces lost, stripped, or damaged screws that secure panels, brackets, and components inside the unit.

Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.

Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.

Secures panels, brackets, hinge covers, and internal components inside your refrigerator. Replace missing or stripped screws for rattle-free assembly.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued and is no longer available.

This part has been discontinued and is no longer available.

Stops refrigerator fan rattling and buzzing noise. This rubber grommet cushions the fan motor to reduce vibration. Simple DIY fix, takes under 30 minutes.

Loud noise from freezer or warm temps? Failed evaporator fan motor stops airflow over coils. DIY fix with basic tools restores proper circulation.

This part has been discontinued and is no longer available.

Hex head sheet metal screw secures appliance panels, brackets, and trim. Replace missing, stripped, or damaged screws to keep covers firmly attached.

This part has been discontinued and is no longer available.

This thermistor is the refrigerator temperature sensor that monitors internal air temperature and helps the control board regulate cooling for safe food storage. It replaces a failed sensor to restore accurate temperature readings and normal cycling. What it does:

• Senses refrigerator/freezer air temperature so the control board can adjust compressor and fan operation
• Can cause improper cooling or erratic cycling when faulty (too warm, too cold, or constant running)
• Helps the appliance respond correctly to user temperature settings and defrost cycles
• Works as part of the temperature control system; not a standalone control module

• Disconnect power to the appliance before beginning any service to avoid shock or injury.
• Handle the sensor tip and wiring gently; avoid kinking or damaging the harness.
• Verify correct connector alignment and secure fit to the harness; test operation after installation.

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.