Parts for Thermador CH30: 05 - Snorkel Page 2 Parts

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Color: metallic. Measures about 13-1/2 inches wide by 5 inches high.

The Grease Filter is an OEM part for Bosch ranges and cooktops. It is responsible for capturing and containing grease, oils, and other vapors produced from cooking to help keep indoor air fresh and prevent buildup. Regular cleaning is important to maintain optimal performance.

Causes of a bad grease filter can include excess buildup that blocks airflow from frequent high-heat cooking. Exposure to flames or excessive heat may cause damage over time as well.

Symptoms of a bad grease filter include:

• Reduced suction power and airflow from the range hood
• Grease accumulation on surrounding surfaces below the hood
• Unpleasant cooking odors escaping into the kitchen rather than being vented outside

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This panel retainer secures a trim or control panel to the appliance, restoring a snug fit and preventing rattles or gaps. It's a small replacement clip used where the factory fastener has broken or worn. What it does:

• Holds a decorative, control, or access panel in place so it sits flush.
• Prevents panel movement, vibration noise, and visible gaps.
• Replaces broken or missing panel fasteners that allow panels to sag or fall out.
• Compatible with factory mounting points to restore original alignment.

• Disconnect power to the appliance before starting any repair.
• Removal/installation typically requires basic hand tools (screwdriver or trim tool) to access the mounting area.
• Align the panel and press or fasten the retainer into the factory slot until it clicks; do not force or overtighten.