Parts for Amana SBDE520SW / P1185201W: 06 - Evaperator And Air Handler Parts

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

Fixes frost buildup in freezer or refrigerator running too cold. This defrost thermostat regulates defrost cycles to prevent ice accumulation. Easy repair.

Secures wiring bundles inside your microwave. Replace this wire tie if it's cracked, broken, or missing to keep internal wires organized and secure.

Secures covers, brackets, and internal panels in your refrigerator. Replace missing, stripped, or corroded screws to restore tight mounting.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Refrigerator not cooling properly? This thermostat kit regulates temperature to restore proper cooling. Moderate DIY repair with basic tools required.

Fix frost buildup in your freezer with this evaporator heater. Restores proper defrost cycle function. Moderately difficult repair, 1-2 hours.

Stops refrigerator fan rattling and buzzing noise. This rubber grommet cushions the fan motor to reduce vibration. Simple DIY fix, takes under 30 minutes.

Refrigerator not cooling properly or running constantly? A faulty evaporator fan motor prevents cold air circulation. Moderate DIY repair restores cooling.

Replacement mounting screw for securing components and housings in place. Order a new screw if yours is stripped, missing, or damaged during repairs.

This part has been discontinued and is no longer available.

This thermistor is the refrigerator temperature sensor that monitors internal air temperature and helps the control board regulate cooling for safe food storage. It replaces a failed sensor to restore accurate temperature readings and normal cycling. What it does:

• Senses refrigerator/freezer air temperature so the control board can adjust compressor and fan operation
• Can cause improper cooling or erratic cycling when faulty (too warm, too cold, or constant running)
• Helps the appliance respond correctly to user temperature settings and defrost cycles
• Works as part of the temperature control system; not a standalone control module

• Disconnect power to the appliance before beginning any service to avoid shock or injury.
• Handle the sensor tip and wiring gently; avoid kinking or damaging the harness.
• Verify correct connector alignment and secure fit to the harness; test operation after installation.