Parts for Thermador SGT36: 08 - Cv2236n Snorkel Parts

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Mounting screw for range hoods. Secures components and panels during installation. Replace if lost, stripped, or corroded for proper assembly.

Aluminum pop rivet for range hoods. Secures panels and components in place. Replace if missing, damaged, or loose to restore proper assembly and fit.

Aluminum pop rivet for range hoods. Secures panels and components in place. Replace if missing, damaged, or loose to restore proper assembly and fit.

This part has been discontinued by the manufacturer and is no longer available.

Main housing welded assembly for cooktops and range hoods. Structural component that forms the outer frame. Replace if cracked, damaged, or warped.

Mounting screw secures cooktop components and panels. Replace if missing, stripped, or corroded. Essential hardware for proper assembly and stability.

This welded wire-channel cover protects and secures appliance wiring along the cabinet frame, preventing abrasion and keeping harnesses routed neatly for reliable operation. It's a direct-fit replacement when the original cover is bent, cracked, or missing. What it does:

• Shields wiring from chafing and contact with sharp edges
• Keeps wire harnesses routed and secured to prevent rubbing and snagging
• Helps reduce the chance of intermittent electrical connections caused by loose wiring
• Restores proper fit and alignment of the channel where wires run

• One welded wire-channel cover

• Disconnect power (unplug or switch off circuit) before inspecting or replacing wiring covers
• Handle wiring gently; avoid pulling or stressing connectors when removing/installing the cover
• Use basic hand tools (screwdriver/fasteners) as required by your model's service instructions
• If wiring or connectors are damaged, replace or repair wiring before reinstalling the cover

Zinc-plated #8-32 wing nut for ranges, cooktops, and grills. Replaces missing, stripped, or corroded wing nuts on burner assemblies and mounting brackets.

This sleeve bearing supports rotating components in your cooktop's ventilation system. Replace if you notice unusual noise or vibration. Verify fit with your model number.

Molex receptacle connector for cooktop wiring harness. Replace if cracked, melted, or corroded to restore proper electrical connections.

Aluminum pop rivet for range hoods. Secures panels and components in place. Replace if missing, damaged, or loose to restore proper assembly and fit.

Aluminum pop rivet for range hoods. Secures panels and components in place. Replace if missing, damaged, or loose to restore proper assembly and fit.