Parts for Maytag MLG19PNAWW: 08 - Door Shroud & Door Latch Assembly (Wash) Parts

This hose clamp secures a rubber or plastic hose to its fitting to maintain a tight, leak-resistant seal. Replace a worn or missing clamp to stop drips and keep appliance water connections secure.

• Fastens a hose to a barb or port to prevent leaks
• Helps keep hoses from slipping off due to vibration or pressure
• Restores proper sealing when a clamp is rusted, bent, or stripped
• Common symptoms: water dripping at a hose joint, loose hose connection, or a clamp that won't tighten

• Disconnect power and shut off the water supply before servicing
• Place a towel to catch residual water when removing hoses
• Position the clamp just behind the hose barb/bead and secure with the appropriate tool
• Restore water and power, then run a quick check for leaks at the connection

This hinge cover is a small trim piece that conceals the door hinge and mounting screws. Replace a cracked or missing cover to restore a clean, finished look and help keep lint and debris out of the hinge cavity.

• Covers and protects the door hinge and screw heads
• Restores a smooth, finished appearance around the hinge opening
• Helps shield the hinge pocket from lint and debris
• Common replacement when the original cover is cracked, missing, or loose

• Disconnect power; for gas units, also shut off the gas supply
• Support the door; loosen/remove hinge screws as needed to access the cover
• Remove the damaged cover; position the new cover and secure per model design
• Verify door closes and aligns properly before returning to service

A small replacement clip that secures the dispenser hose to the dispenser assembly, helping keep the hose seated and reducing the chance of leaks or disconnection. Simple, durable part for restoring proper hose retention. What it does:

• Holds the dispenser/hose connection firmly in place to prevent the hose from slipping free
• Helps reduce water leaks and intermittent dispenser flow caused by a loose hose
• Keeps hose routing stable to avoid rubbing or wear against nearby components
• Works with the dispenser assembly to maintain proper alignment and seal

• One retainer as shown

• Disconnect power and water supply before starting any repair
• Access the dispenser area per your appliance's service instructions; remove trim or panels if required
• Snap the retainer over the hose at the dispenser connection until it seats; verify the hose is fully seated
• If you see damage to the hose or fittings, replace those parts before finishing