Parts for Thermador SGNCV36GW: 08 - Snorkel Parts

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

This lock washer secures fasteners by biting into the mating surface to resist loosening from vibration and thermal cycling. It's a small but critical retaining part used on appliance assemblies where a secure, vibration-resistant connection is required. What it does

• Provides a spring clamp action that helps keep bolts and screws from backing out under vibration
• Maintains tension on threaded connections during thermal expansion and contraction
• Commonly used on motor mounts, pump assemblies, and panels that experience movement
• Can reduce intermittent electrical/grounding issues caused by loose hardware

• One lock washer

• Inspect threads and mating surfaces; replace any damaged fasteners before installing the washer
• Install with the correct-sized bolt or screw; washer must fit snugly to function properly
• Tighten to manufacturer torque specifications when available; avoid over-tightening
• Disconnect power and follow all safety precautions before servicing the appliance

This panel retainer secures a trim or control panel to the appliance, restoring a snug fit and preventing rattles or gaps. It's a small replacement clip used where the factory fastener has broken or worn. What it does:

• Holds a decorative, control, or access panel in place so it sits flush.
• Prevents panel movement, vibration noise, and visible gaps.
• Replaces broken or missing panel fasteners that allow panels to sag or fall out.
• Compatible with factory mounting points to restore original alignment.

• Disconnect power to the appliance before starting any repair.
• Removal/installation typically requires basic hand tools (screwdriver or trim tool) to access the mounting area.
• Align the panel and press or fasten the retainer into the factory slot until it clicks; do not force or overtighten.

This welded wire-channel cover protects and secures appliance wiring along the cabinet frame, preventing abrasion and keeping harnesses routed neatly for reliable operation. It's a direct-fit replacement when the original cover is bent, cracked, or missing. What it does:

• Shields wiring from chafing and contact with sharp edges
• Keeps wire harnesses routed and secured to prevent rubbing and snagging
• Helps reduce the chance of intermittent electrical connections caused by loose wiring
• Restores proper fit and alignment of the channel where wires run

• One welded wire-channel cover

• Disconnect power (unplug or switch off circuit) before inspecting or replacing wiring covers
• Handle wiring gently; avoid pulling or stressing connectors when removing/installing the cover
• Use basic hand tools (screwdriver/fasteners) as required by your model's service instructions
• If wiring or connectors are damaged, replace or repair wiring before reinstalling the cover

This part has been discontinued by the manufacturer and is no longer available.

This part has been discontinued by the manufacturer and is no longer available.

Color: metallic. Measures about 13-1/2 inches wide by 5 inches high.

The Grease Filter is an OEM part for Bosch ranges and cooktops. It is responsible for capturing and containing grease, oils, and other vapors produced from cooking to help keep indoor air fresh and prevent buildup. Regular cleaning is important to maintain optimal performance.

Causes of a bad grease filter can include excess buildup that blocks airflow from frequent high-heat cooking. Exposure to flames or excessive heat may cause damage over time as well.

Symptoms of a bad grease filter include:

• Reduced suction power and airflow from the range hood
• Grease accumulation on surrounding surfaces below the hood
• Unpleasant cooking odors escaping into the kitchen rather than being vented outside

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.