Parts for Thermador SC302T: 10 - Door 30`` Parts

This a Thermador oven door hinge.

This is a replacement glass panel for the appliance's front panel. It restores a clean, durable surface and helps protect the components behind it when the original glass is cracked, chipped, or shattered.

• Forms the exterior glass surface on the appliance's front panel
• Helps shield underlying components from spills and impacts
• Restores proper fit and appearance when the original glass is damaged
• Common symptoms: visible cracks/chips, shattered glass, loose or rattling panel, missing glass

• Disconnect power; also shut off gas before servicing
• Wear cut-resistant gloves and eye protection; handle glass carefully
• Support the door or front panel during removal to prevent stress or drops
• Transfer and reuse existing trim, logos, gaskets, and hardware as designed; do not overtighten fasteners

This door strike is the small metal latch that engages the door catch so the appliance door closes and stays secure. Replaces a worn or damaged strike to restore proper door latching and safe operation. What it does:

• Provides the mating latch surface for the door catch so the door stays closed
• Restores secure door closure when a worn or bent strike prevents latching
• Can help resolve symptoms such as a door that won't stay closed, won't latch, or prevents the unit from starting
• Black oxide finish resists corrosion and reduces visible wear

• One door strike (black oxide)

• Disconnect power (and water for dishwashers) before beginning any repair
• Remove door panel or access trim to reach the strike; keep screws and fasteners organized
• Align strike carefully with the door catch; tighten screws snugly but avoid over-torquing
• Test door operation and any door-interlock switches before reassembling the unit

This spacer secures and maintains proper clearance between mounting surfaces, helping panels and components align correctly for smooth operation. Use it when a worn or missing spacer causes loose fittings or misalignment. What it does

• Keeps correct distance between panels or mounting brackets to prevent rubbing and misalignment
• Stabilizes parts to reduce vibration and movement during operation
• Helps restore proper panel fit and prevent gaps that can catch or chafe wiring
• Can address symptoms such as loose or misaligned panels, rattling, or uneven seams

• Disconnect power and water before beginning any repair
• Remove applicable panels or trim to access the mounting location; keep track of fasteners
• Install spacer in the same orientation and location as the original; replace any damaged fasteners

The oven door gasket is the heat-resistant seal around the 30-inch oven cavity. It helps the oven reach and hold temperature, preventing heat and steam leaks, and replaces a worn or damaged seal for consistent baking results.

• Seals the door-to-cavity gap to limit heat and moisture loss
• Restores proper door compression to help maintain accurate temperatures and normal preheat times
• Replaces gaskets that are torn, frayed, flattened, brittle, or stretched
• Common symptoms: hot air or steam escaping at door edges, temperature fluctuations, longer cook times, or a door that no longer closes snugly

• Disconnect power and allow the oven to cool completely before servicing
• Open the door and remove the old gasket, noting seam orientation and where the ends seat
• Clean the mating surfaces; install the new gasket with the seam at the bottom center, seating the ends fully into the factory holes/retainers without overstretching
• Close the door and check for uniform contact around the perimeter

This a Thermador oven door hinge.