Parts for Thermador GSC30CVWC: 14 - Remote Ventilator Parts

This genuine OEM part is a blower wheel for range hoods. The blower wheel is the main fan that is used to circulate air above the stove. If the blower is no longer turning on, not working as efficiently, or barely operating, it will need to be replaced.To begin, make sure that the range and range hood are unplugged. Once they have been powered off, proceed to remove the bottom panel of the range hood by unfastening the mounting screws that secure it. Once removed, locate the old blower wheel. Remove the mounting screws that attach it to the range vent and pull it out of its place. Proceed to install the new blower wheel by fastening the screws that attach it to the vent. Once secured, reinstall the bottom panel of the range hood.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador brand ranges and range hoods.

This TH capacitor is an electrical control-circuit capacitor used on compatible Bosch appliances to help stabilize voltage and filter electrical noise for reliable control-board operation. Replacing a failed capacitor can address intermittent control issues. What it does

• Stabilizes control-board voltage and helps filter electrical noise that can cause erratic behavior.
• Supports reliable startup and operation of control circuits.
• Common symptom link: intermittent or unexplained control-board errors, erratic or non-responsive controls.
• Common symptom link: appliance displays control or error codes related to electronics or intermittently fails to start.

• Disconnect power to the appliance at the breaker before servicing to avoid shock.
• Discharge any capacitors and allow boards to sit before touching components; use appropriate ESD precautions.
• Only replace with the exact part number; confirm orientation and connector fit before reassembly.

This wiring harness connects the cooktop element to the range control, allowing the control board to power and regulate the heating element. Replacing a damaged harness restores proper electrical connection and element response. What it does

• Transfers power and control signals between the control board and a surface element
• Restores consistent element heating when a broken or burned wire prevents operation
• Prevents intermittent element response caused by loose or corroded terminals
• Helps eliminate visible arcing or heat damage at the connector end when worn

• One element control harness as pictured

• Disconnect all power to the appliance before starting repair to avoid shock
• Access may require removing the cooktop or control console; refer to your model's service instructions
• Inspect mating connectors and element terminals for damage; replace if corroded or melted
• Secure harness routing to avoid contact with hot surfaces and moving parts

This wiring harness connects the cooktop control module to the cooktop's electrical components, restoring reliable signal and power routing so burners and controls operate correctly. What it does

• Transfers power and control signals between the cooktop control/ignition module and cooktop components
• Commonly replaces damaged or burnt wiring that causes burners or controls to fail
• Can resolve intermittent power issues, non-responsive controls, or ignition failures linked to wiring
• Matches factory connector types and routing for correct fit and function

• One cooktop wiring harness (ESC30)

• Disconnect all power to the appliance before starting any repair
• Match connector shapes and wire colors to the original harness; do not force connections
• Route and secure the harness to prevent pinching or contact with hot surfaces

This P13 harness is a factory-style wire connector harness that delivers power and signal connections between components for proper appliance operation. It replaces a damaged or worn harness to restore reliable electrical connections. What it does:

• Connects control signals and power between the control board and downstream components
• Restores proper electrical continuity when original wiring is frayed, burned, or broken
• Can stop intermittent operation or faults caused by loose or corroded connectors
• Helps eliminate error codes or component failures tied to a bad harness

• Disconnect the appliance from power before servicing to avoid shock or damage
• Compare the replacement harness to the original to ensure matching connector types and pin orientation
• Carefully seat connectors until they click; avoid pulling on wires when disconnecting