Parts for Kenmore 106.8752070 (1068752070, 106 8752070): Air Flow And Control Parts

Size: 1/4 inch hex head, 10-12 x 1/2 inch.

This oval run capacitor provides the steady-phase shift motors need to run efficiently at 440V, restoring normal motor operation and improving reliability. Use it to replace a failed or weak run capacitor in compatible appliances. What it does:

• Supplies a steady AC phase shift to the motor for continuous operation
• Helps eliminate symptoms like slow motor speed, reduced torque, or intermittent operation
• Supports reliable compressor/fan/motor performance when matched to the original specs
• Works as a direct replacement when the original part is the same physical style and voltage

• Disconnect power to the appliance before beginning service to avoid shock
• Discharge the capacitor before handling; capacitors can hold a charge even when powered off
• Replace with the same voltage, capacitance, and physical configuration as the original

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This screw is used to secure the handle end cap to the center of the door. The screw size measures 8-18 x 1/2 inches.

This seal strip replaces a worn or damaged door gasket edge to restore a proper seal and help the appliance maintain temperature and operate quietly. It's a direct-fit service part used where a continuous seal is required. What it does:

• Provides a flexible barrier along the door/frame to reduce air leaks and heat/cold loss
• Helps prevent moisture buildup and improves energy efficiency when sealing is restored
• Reduces rattling and vibration caused by a compressed or torn seal edge
• Commonly replaced when the strip is torn, missing, or no longer adheres properly

• One seal strip

• Disconnect power to the appliance before servicing to avoid electrical or burn hazards
• Clean and dry the mounting surface; remove old adhesive or residue for best adhesion
• Align the strip carefully and press firmly; allow any adhesive to cure per manufacturer instructions

A small retaining nut used to fasten and secure appliance components so they stay in place during normal use. Replaces worn or missing nuts to restore proper fit and reduce movement or rattling. What it does:

• Secures mating parts to prevent loosening from vibration or operation
• Helps maintain proper alignment of panels, brackets or assemblies
• Stops components from shifting, which can cause noise or improper operation
• Simple mechanical fastener — no electrical function

• One retaining nut

• Disconnect power to the appliance before starting any repair
• Use the correct size wrench or socket to snug the nut; avoid overtightening
• If the nut threads onto a stud or bolt, inspect threads for damage and replace mating hardware if worn

Size: 8-32 x 1/4 inch.