Brian for Model Number SHX45P05UC/60 My dishwasher would not close nor reset. I was told I needed to replace the door latch part #00438026 which I did. The washer ran one cycle and kept beeping at the end of the cycle. I opened the door and went to run another load and again the door won't close. It's like the latch is not being reset or something. Is there a sensor or some other part that has gone bad?
Answer Brian, No, there are no " sensor or some other part that has gone bad " and you did install the correct door switch assembly 00438026 / 00438026 But you'll need to check the wiring for loose or damaged connections, and check the fascia mounting plate and tabs to make sure the assembly is properly installed and operating properly. " Remove T-20 Torx fascia panel screws from inner door. Lower fascia panel from door. Locate door latch in console. Bend out console metal tabs to allow latch removal/installation." NOTE:Door latches for UC/14 & up models are different than UC/06 - UC/12 models -- they cannot be interchanged. Must replace strike plate & door latch together. You'll need to check the door latch and handle to make sure everything is aligned and operating properly. Read More... Answered by AppliancePartsPros.com | Tuesday, January 9, 2018